Clutch type and replacement on a Chim 450
Discussion
Had the clutch start to slip quite badly on my 450, and my local garage (non TVR specialist) are prepared to change the clutch if I get the parts.....
Is this a sensible road to go down, or should I find a garage that is prepared to source parts? If the former, any advice on what I should be buying for them to fit? If the latter, any recommendations in the Aberdeen/Aberdeenshire area? I got the main service and rad swap done at Dreadnought, who did a fine job, just a fair hassle to get the car there and back.
Local garage has done work on my normal car and did a fine job, I am just concerned I guess about me buying the wrong parts, and their apparent hesitance to source this themselves.
Any advice from the greater brain gratefully received!!
Is this a sensible road to go down, or should I find a garage that is prepared to source parts? If the former, any advice on what I should be buying for them to fit? If the latter, any recommendations in the Aberdeen/Aberdeenshire area? I got the main service and rad swap done at Dreadnought, who did a fine job, just a fair hassle to get the car there and back.
Local garage has done work on my normal car and did a fine job, I am just concerned I guess about me buying the wrong parts, and their apparent hesitance to source this themselves.
Any advice from the greater brain gratefully received!!
I have only once had a new clutch on my 450. I let the specialist source the parts (they came from TVR power) and although the clutch looked fine it didnt work properly. So it had to come out again. Still looked fine, but new clutch despatched from power and this time it worked fine.
If I had supplied the part I would have been footing the bill to take it all apart twice rather than nodding sympathetically as the garage tell me how much time it took to do for the fixed price....
If I had supplied the part I would have been footing the bill to take it all apart twice rather than nodding sympathetically as the garage tell me how much time it took to do for the fixed price....
Would agree with Lewis, speak to V8 Developments and get the right bits. Don't mess about replace everything, including release bearing and arm. With a 450 I would get the 500 clutch, slightly uprated compared to the 400 and above, so worth the extra cash.
Did mine on the drive with Axel stands which would have been easy except some t**t put the bolts back in the wrong place so some of the bell housing bolts had bottomed out and were as tight as a tight thing.
Good luck.
Paul.
Did mine on the drive with Axel stands which would have been easy except some t**t put the bolts back in the wrong place so some of the bell housing bolts had bottomed out and were as tight as a tight thing.
Good luck.
Paul.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff



