RV8 cam end float question....
Discussion
Hi chaps... Not quite chim related but im sure one of you will know...
Im rebuilding a 3.5 rv8 for my mini, and on removing the dizzy retaining plate/brcket and trying to remove it by twisting, i noticed around 3mm of cam end float??? this surely cant be right??
also the dizzy wont come out, how should it be released? it twists tho.
Im rebuilding a 3.5 rv8 for my mini, and on removing the dizzy retaining plate/brcket and trying to remove it by twisting, i noticed around 3mm of cam end float??? this surely cant be right??
also the dizzy wont come out, how should it be released? it twists tho.
Are you talking about gear lash by any chance? most of the cams do seem to have a couple of mm endfloat, but you have to flick it up & down through the valley to detect.
Just lever the dizzy up gently, there is only a rubber oring and the clamp that holds it in.. but if it's a 3.5 there could be lots of goo / grime gluing it together after all these years. Might be easier to remove the timing cover and clean/soak the part.
Just lever the dizzy up gently, there is only a rubber oring and the clamp that holds it in.. but if it's a 3.5 there could be lots of goo / grime gluing it together after all these years. Might be easier to remove the timing cover and clean/soak the part.
spend said:
Are you talking about gear lash by any chance? most of the cams do seem to have a couple of mm endfloat, but you have to flick it up & down through the valley to detect.
Just lever the dizzy up gently, there is only a rubber oring and the clamp that holds it in.. but if it's a 3.5 there could be lots of goo / grime gluing it together after all these years. Might be easier to remove the timing cover and clean/soak the part.
It occurs when i turn the rotor, i can clearly see the cam moving quite a bit. Just lever the dizzy up gently, there is only a rubber oring and the clamp that holds it in.. but if it's a 3.5 there could be lots of goo / grime gluing it together after all these years. Might be easier to remove the timing cover and clean/soak the part.
As for removal, i assumed it was probably an o-ring sticking, but wanted to check!
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


