Running hot, I think....some advice please
Running hot, I think....some advice please
Author
Discussion

Nosh

Original Poster:

982 posts

198 months

Friday 6th August 2010
quotequote all
Getting to know the Chim (4 L 93 'L') very well now and it has surpassed my expectations....absolutley love it...

But I have noticed the car runs hot - bloody hot, I think.

The gauge soon gets up to 90, and pretty much stays there - it sometimes creeps a tiny bit when standing for a while on tickover and the fans are whirring away.

Is this the normal temp of a car of this year, with the older dials?

Thanks
Nosh.

Oh, and driving home tonight, I noticed the temp nearly at 100!! Stopped the car and turned off the lights before ther engine and the needle dropped to 90! Swich the lights back on, and the needle jumped up to nearly 100! Elec short?

chimaera1855

334 posts

199 months

Friday 6th August 2010
quotequote all
ahaha welcome to the TVR world.dont worry 90 is normal as 100.as long as ur fans kick at 100 and the temp goes down to 90 u are fine.some cars run at 110.put an oil cooler and change the Y piece.i live in malaysia so i know how to keep my car cool.min runs all the time at 80 to 90.

bigdods

7,175 posts

258 months

Friday 6th August 2010
quotequote all
90 is normal ish if you are sitting in traffic but once moving should drop down. But the dash guage isnt very accurate. The fans should come on , run for a short time then go off again. If in traffic for a while they will stay on longer. They shouldnt be running if you have been moving.


peaktorque

1,807 posts

242 months

Friday 6th August 2010
quotequote all
Mine has never exceeded 90c in my ownership, that includes even the hottest days stuck in traffic....

More than 100c would concern me though.

chimaera1855

334 posts

199 months

Friday 6th August 2010
quotequote all
as they say all tvrs are different thats why we love them so much right???

kenny.R400

1,212 posts

271 months

Saturday 7th August 2010
quotequote all
First off buy A cheap Maplins infra red laser poiner thermometer , then you can cut through all the crap and know exactly how hot the motor actually is.

Secondly on my '93 430 it had the full size number plate nicely positioned across the mesh blocking half of the air flow.........that got moved on first day of ownership after I saw its temps.......temp now sits happy at 80-90 no matter what.

Strange that on the '98 400 I've just sold temp struggled to climb above 70, even in traffic.........all proven with the above mentioned tool of coursesmile

Cheers,
Kenny



Edited by kenny.R400 on Saturday 7th August 06:32

andy450

145 posts

197 months

Saturday 7th August 2010
quotequote all
would agree with "kenny r400", my 450 temp gauge would struggle to make "normal" running temp,got temp gun and checked various points around the engine coolant system (thermostat housing,swirl pot,rad,hoses etc)and found that all was ok and that my temp gauge was under reading by 10degs(consistantly from cold through warm up till full opperating temp,fans coming in and out and stabilising and reducing temps accordingly), after reading through various posts on here have come to the conclusion that its tne sender that is probably at fault,will fitt new one when ive decided wether or not to use the rr temp sender possition with adapter,or to keep origanal tvr position(various threads on here!!!) once youve established wether the gauge readings are true or not with the temp gun it will give you peace of mind or point you in the direction of any probs (hopefully not) you may have.
good luck

Edited by andy450 on Saturday 7th August 09:22

Ozstyle

392 posts

254 months

Saturday 7th August 2010
quotequote all
My water temperature gauge used to read low by about 10 degrees at operating temperature.
Thought this was due to faulty sender, but found a 10 ohm resistor in the wiring at the back of the guage, I believe it was not uncommon for TVR to fit this mod at times. Removal fixed the low reading.

Oz

quattrophenia

1,103 posts

229 months

Saturday 7th August 2010
quotequote all
bigdods said:
90 is normal ish if you are sitting in traffic but once moving should drop down. But the dash guage isnt very accurate. The fans should come on , run for a short time then go off again. If in traffic for a while they will stay on longer. They shouldnt be running if you have been moving.
mine sits at 75-80 on the move but quickly rises to 90 in town. I have noticed it creep up to 95 once. The only thing that bothers me is that the fan cuts straight in at around 90ish but only stays on for about a minute before shutting off. The temp guage shows the same as when the fan cut in. Shouldnt the fan stay on till the guage reads under 90?
Any how I'm going to have the override switch for peice of mind.

Silver

4,373 posts

257 months

Saturday 7th August 2010
quotequote all
Mine sits at about 90 in traffic as well. It used to get to boiling point but I got a new rad and faulty otter switch replaced which sorted it.

Runs at about 70 when moving.

bigdods

7,175 posts

258 months

Saturday 7th August 2010
quotequote all
check that both fans come on, and that they are both blowing air into the engine bay. Its not unusual to find one either not working at all or with the plug on the wrong way round so its sucking instead of blowing.

Nosh

Original Poster:

982 posts

198 months

Saturday 7th August 2010
quotequote all
Silver said:
Mine sits at about 90 in traffic as well. It used to get to boiling point but I got a new rad and faulty otter switch replaced which sorted it.

Runs at about 70 when moving.
Whats an otter switch and how do I know I have one?

Thanks
Nosh

Nosh

Original Poster:

982 posts

198 months

Saturday 7th August 2010
quotequote all
bigdods said:
check that both fans come on, and that they are both blowing air into the engine bay. Its not unusual to find one either not working at all or with the plug on the wrong way round so its sucking instead of blowing.
Thanks - Will check that tomorrow - had far too much fun today to check the forum! Doh!!

Nosh

dogbucket

1,256 posts

232 months

Wednesday 11th August 2010
quotequote all
Mine seems to be running a bit hotter this year.

What would be a normal temp drop across the rad if stationary using one of those infra red jobbies?

M@H

11,298 posts

303 months

Wednesday 11th August 2010
quotequote all
Nosh said:
Silver said:
Mine sits at about 90 in traffic as well. It used to get to boiling point but I got a new rad and faulty otter switch replaced which sorted it.

Runs at about 70 when moving.
Whats an otter switch and how do I know I have one?

Thanks
Nosh
You do have one. It is the switch that turns the fans on and off. On your model it should be tapped into the swirl pot, basically it looks like a big brass nut with a two wire electrical connector to it.

It detects the temperature of the coolant water in the swirl pot and allows current to flow (switches on) at a certain temperature. These are available in a range of temperature switches from about 78 degrees up to about 90-95 from memory.

Some owners fit lower temperature ones if their cooling systems are a bit sluggish, equally if someone fits a higher temperature one in error then running temp will be higher as a result.

Another thing to consider is the thermostat of course. If someone has fitted a "standard" landrover thermostat to your v8 then it may well not be opening till 85 upwards anyway, I think TVRs have a 73-75 degree one.

Between these two components you can dictate the normal running temerature range of your engine.

Cheers,
Matt.

Edited by M@H on Wednesday 11th August 15:48