TEST DRIVE.. but advice appreciated
Discussion
Hi
test drove couple of Chims today
Quite impressed overall. But i found the clutch action a bit heavy for my dodgy knee, especially in one of the cars..
Is there a way to lighten the clutch action ( i noticed the clutch in a 4.0 cerb seems v light in comparison)
also did the Chims have LSD fitted standard? is there a good LSD that can be recommended?
any good garages in London area good for TVR service/upgrades, cos i will also want a roll bar and exhaust mod done
sorry for all the questions but im still learning about TVRs!
Thanks
test drove couple of Chims today
Quite impressed overall. But i found the clutch action a bit heavy for my dodgy knee, especially in one of the cars..
Is there a way to lighten the clutch action ( i noticed the clutch in a 4.0 cerb seems v light in comparison)
also did the Chims have LSD fitted standard? is there a good LSD that can be recommended?
any good garages in London area good for TVR service/upgrades, cos i will also want a roll bar and exhaust mod done
sorry for all the questions but im still learning about TVRs!
Thanks
wow thanks, was told by TVR barnet (trimar) that no chimeras had LSDs!!
any good recommendations for servicing in london area?
If i cant find a way to lighten the clutch action then dont think i will get on too well with a chimera OR poss better off with a cerb, as clutch seemed great!
any good recommendations for servicing in london area?
If i cant find a way to lighten the clutch action then dont think i will get on too well with a chimera OR poss better off with a cerb, as clutch seemed great!
the clutch system is a simple hydraulic system of master and slave. therefore, to lighten the pedal you would need to get fitted a smaller bore master cylinder. this would mean that for a given amount of pedal travel, you would move a lower volume of clutch fluid to the slave, hence a longer push of the pedal would be needed to disengage the clutch, but the effort would be reduced. In extreme cases I would have thought it would be possible to fit a remote servo to the clutch system or have some form of electric assistance.
Good luck
Schmo
Good luck
Schmo
If the fluid in the system is old then it may well have absorbed a small amount of moisture which would lead to a heavy pedal. This and possible stiffness of the cluth fork (maybe down to lack of use) are probably why the op found the clutch to be heavy and could also be why I found a few with heavy and a few with light(er) clutches
Edited by dog man on Monday 9th August 22:07
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


