Heater Valve
Heater Valve
Author
Discussion

Jonny cobra

Original Poster:

615 posts

243 months

Monday 9th August 2010
quotequote all
Hi guys & gals i was useing the heater control yesterday and ping it just spun round . So befor i remove the dash top , Where is the heater valve so i can see if it has come off the valve. { the cable that is } How is the cable connected to the heater disk please ??


JC

peaktorque

1,807 posts

242 months

Monday 9th August 2010
quotequote all
On mine it is located just under the lower part of the dash on the N/S of the passenger footwell, near the battery.

You can probably see where the two pipes enter the cabin from the transmission tunnel, just follow them round and you should find the valve.

smile

Jonny cobra

Original Poster:

615 posts

243 months

Monday 9th August 2010
quotequote all
Thank you for your reply m8 .


JC,

taylormj4

1,635 posts

297 months

Tuesday 10th August 2010
quotequote all
Jonny cobra said:
Hi guys & gals i was useing the heater control yesterday and ping it just spun round . So befor i remove the dash top , Where is the heater valve so i can see if it has come off the valve. { the cable that is } How is the cable connected to the heater disk please ??


JC
Hi, this happened to mine (assuming it is the bottom of the two wheels that you mean!). Thought the cable had snapped but no TVR have secured the cable to the wheel using a screw that is effectively upside down, i.e. it goes up through the cable eyelet into the underside of the wheel, so of course it rattles out over time. Make sure you have threadlock to hand before you go in !

spend

12,581 posts

282 months

Tuesday 10th August 2010
quotequote all
Yes the grub screw loosening seems to be the most common problem. I'd take your time and adjust the cables whilst you are in there. With care you can reach the far ends of the cables to feel what kind of throw there should be to activate the valve and the flap in the mixer.

IIRC its easier if you actually dismount the whole wheel assembly and tilt it for access, the cable geometry doesn't change when you bolt it back in? (it's been a long time since I played with mine & I didn't use loctite..)

Jonny cobra

Original Poster:

615 posts

243 months

Tuesday 10th August 2010
quotequote all
taylormj4 said:
Jonny cobra said:
Hi guys & gals i was useing the heater control yesterday and ping it just spun round . So befor i remove the dash top , Where is the heater valve so i can see if it has come off the valve. { the cable that is } How is the cable connected to the heater disk please ??


JC
Hi, this happened to mine (assuming it is the bottom of the two wheels that you mean!). Thought the cable had snapped but no TVR have secured the cable to the wheel using a screw that is effectively upside down, i.e. it goes up through the cable eyelet into the underside of the wheel, so of course it rattles out over time. Make sure you have threadlock to hand before you go in !
Yes it is the bottom disc .And thank you guys for giving this info .

JC