Wiring help
Wiring help
Author
Discussion

Pink_Floyd

Original Poster:

900 posts

252 months

Monday 9th August 2010
quotequote all
As I am putting the car back together I thought that I would sort out/tidy up the wiring in the engine bay, ie reduce the length of many of the leads. I do however have a couple of connectors that are not connected to anything, in pic below with red and blue arrow, what are they for they sit just behind the alternator.
also the connector with the green arrow sits on the chasis and is connected to a wire which then goes behind the rad, any idea as to what it controls?

I have fitted a sensor for oil temp and am hoping that I can use one of the wires from the unused connectors, anyone know where they may be avaliable in the cabin/dash board.

Pink_Floyd

Original Poster:

900 posts

252 months

Monday 9th August 2010
quotequote all
Quinny said:
Green "could" be ice detector, Blue "looks" like an exhaust lamda probe connection
The blue one looks similar to the lambda probe connectors but they are both connected this is another one.
The green looks similar to the ice detector but that is also connected and in situ.
I am wondering if the red and blue are to do with the air con if I had it fitted?

TVR Beaver

2,874 posts

211 months

Tuesday 10th August 2010
quotequote all
I thought the Blue was for the air con if fitted?.. driving

spend

12,581 posts

282 months

Tuesday 10th August 2010
quotequote all
For what you want to do, running an extra wire alongside the alt to ignition light is easy enough. I would make sure you also make a connector so that the dash panel can be removed by unplugging the loom, nothing more annoying than trying to pull the panel out and its fixed wink

You would have to strip a lot more dash to get to suitable connectors or strip / rebind oodles of loom where most of that 'spare' wiring is accessible in the cabin.

Ozstyle

392 posts

254 months

Tuesday 10th August 2010
quotequote all
Hi,
Blue is definately 2 pin circular for air con compressor.
Red not sure, but could be the connector for otter switch fitted in the thermostat housing on Rover models with air con.

Chassis 33

6,194 posts

313 months

Tuesday 10th August 2010
quotequote all
The round connector, as has been stated, is the Air Con clutch - it is similar length to the alternator wires as the air con pump sits right by the alternator (assuming its a serp engine).
The green arrow - carbon canister/purge valve?

What are the wire colours of the red arrow? Can you use http://www.gomog.com/allmorgan/HOTWIREWIRING.jpg to trace the wires back?


Regards
Iain