4 beeps on locking means?
Discussion
Nickccc said:
Yep mine was the boot sensor when my alarm did this. Look at the left hand side
with the boot open in the corner you'll see a small l shaped plunger that the folding
mechanism extends when you close the boot. Give it a wiggle as it can look ok but be
broken.
Is it the same as the boot light switch?with the boot open in the corner you'll see a small l shaped plunger that the folding
mechanism extends when you close the boot. Give it a wiggle as it can look ok but be
broken.
Poledriver said:
Nickccc said:
Yep mine was the boot sensor when my alarm did this. Look at the left hand side
with the boot open in the corner you'll see a small l shaped plunger that the folding
mechanism extends when you close the boot. Give it a wiggle as it can look ok but be
broken.
Is it the same as the boot light switch?with the boot open in the corner you'll see a small l shaped plunger that the folding
mechanism extends when you close the boot. Give it a wiggle as it can look ok but be
broken.

Nickccc said:
Yep mine was the boot sensor when my alarm did this. Look at the left hand side
with the boot open in the corner you'll see a small l shaped plunger that the folding
mechanism extends when you close the boot. Give it a wiggle as it can look ok but be
broken.
Anyone know how to fix this sensor back in place? For some reason I took mine out, and it seems as though you have to cut a hole in the side of the car to put it back in!? lolwith the boot open in the corner you'll see a small l shaped plunger that the folding
mechanism extends when you close the boot. Give it a wiggle as it can look ok but be
broken.
There's a small hole where it should sit, a thread comes out of the back of the
sensor. Reach up above the wheel well from inside the boot there will be a single
wire with a washer on the end of it, pop this over the thread and put a nut on to
secure it.
Update it isn't a thread on the sensor it is a bolt through it .

sensor. Reach up above the wheel well from inside the boot there will be a single
wire with a washer on the end of it, pop this over the thread and put a nut on to
secure it.
Update it isn't a thread on the sensor it is a bolt through it .

Edited by Nickccc on Thursday 12th August 14:20
Gassing Station | Cerbera | Top of Page | What's New | My Stuff



