Serpentine belt tensioner
Discussion
Anyone know if the bearing in the pulley can be replaced (appears to be moulded in) ? Think I recall this topic coming up a little while back but "search" is not working.
Failing that can the pulley be purchased separately ? Have had a look around a couple of TVR suppliers websites, tried various descriptions but can't find it. Found one on Ebay for a Range Rover but complete with tensioner mechanism, seems a bit over the top when its just the bearing squealing.
Short term fix I've popped the dust covers off the old one and re-greased it.
Failing that can the pulley be purchased separately ? Have had a look around a couple of TVR suppliers websites, tried various descriptions but can't find it. Found one on Ebay for a Range Rover but complete with tensioner mechanism, seems a bit over the top when its just the bearing squealing.
Short term fix I've popped the dust covers off the old one and re-greased it.
Yes,if your careful the lip can be ground out and the old bearing pressed out(easy with a vice)when refitting the new bearing it's just a case of using a small smear of bearing fit or similar around the outer case of the bearing and pressing in again use wood,large sockets,or similar when pressing as the wheel itself is very brittle and will not stand up to abuse
the bearing is used for motorcycle wheel bearings amongst other thing's and is very easy to obtain from bearing stockist's motorcycle workshop's etc,i think this job is only worth doing the once as i would not like the idea or pressing out again once the stud lock as cured and those wheels get brittle with age(mine was done like this over 3 years ago)anyway i would just change to a quality unit like this to be honest,Dayco is a respected and trusted brand in my trade http://cgi.ebay.co.uk/LAND-ROVER-DISCOVERY-II-V8-F... as if not done correctly and the thing fall's apart it's going to leave you stranded,if one of these come into the workshop i would not just replace the bearing through fear of come back
it's all in that last statement really for the small saving don't bother 
the bearing is used for motorcycle wheel bearings amongst other thing's and is very easy to obtain from bearing stockist's motorcycle workshop's etc,i think this job is only worth doing the once as i would not like the idea or pressing out again once the stud lock as cured and those wheels get brittle with age(mine was done like this over 3 years ago)anyway i would just change to a quality unit like this to be honest,Dayco is a respected and trusted brand in my trade http://cgi.ebay.co.uk/LAND-ROVER-DISCOVERY-II-V8-F... as if not done correctly and the thing fall's apart it's going to leave you stranded,if one of these come into the workshop i would not just replace the bearing through fear of come back
it's all in that last statement really for the small saving don't bother 
Edited by Simon says on Friday 13th August 09:34
Pupp said:
Take the opportunity to do away with the thing and also replace the big ugly casting it mounts to with the lovely JE alternator mount. More engine bay space, less weight, less complexity, shorter belt, less frictional losses. No brainer 
That's my next mod 
decided on that one after the recent post on the matter 
haircutmike said:
One for sale on classified for £15.00
Thanks, seller has already been in touch, but its the puley I'm after not the tensioner.Might try your "cut the bearing out" idea Simon (As I already have a bearing). Appreciate in a garage the time taken would probably cost more than any saving on parts ?
On the other hand, this things whizzing round at a hell of a speed maybe I should get the whole thing, could make a bit of a mess if it comes apart. Just seems a waste buying all that when its just the bearing thats faulty.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff



