Injector replacement
Injector replacement
Author
Discussion

More Steam

Original Poster:

698 posts

221 months

Sunday 15th August 2010
quotequote all
How easy a job is it to change out the injector o'rings? I guess the plenum has to at least be slack and the power steering reservoir moved. Is there anything else?

More Steam

Original Poster:

698 posts

221 months

Sunday 15th August 2010
quotequote all
Sounds like a small nightmare to me.

TVR Beaver

2,874 posts

211 months

Sunday 15th August 2010
quotequote all
getting it back on is more fun!.. if you put your injectors in the rail it's like trying to train an octopus!! laugh

jenkotvr

688 posts

205 months

Monday 16th August 2010
quotequote all
Quinny said:
Not a massive job, but easy to cause damage if you go at it like a bull at a gatesmile

De-pressurise fuel system, I do this by releasing the clip on the pipe and just letting the fuel spill... (Cold engine obviously)

Remove feed and return pipes
Unclip stepper motor connector
Remove bypass pipe from back of plenumn
Unclip throttle pot connector
Remove inlet elbow
Remove plenumn

I'd also remove the trumpet base (Shove some rags down the inlet manifold)

Remove all connectors from injectors etc

Then undo the 4 bolts holding the rail in place....


You now have a choicesmile You can remove the rail and leave the injectors in place (By removing the clips on the top of each injector)

Or

You can try and remobe the whole lot..

Personally I go for the second option... and the way I go about it is to "gently lever" the rail, and ease it away from the manifold...

You need to take your time, and not force anything, but you also need to understand that it doesn't just come away easily..

Be patient and just keep easing it up, sooner or later it'll pop offsmile
Come on Quinny, wheres the video? hehe