not starting again help need it for tomorrow
Discussion
This is strange worked fine before I parked it up now though it won't start stood for 3 weeks. I does however have fuel, sparks and cranks over fine just wont start.
Earlier last month I replace the coil and ignition amp which cured the not starting issue but now it's back and I have flooded it plugs wet. It did try to cough into life at one point but now nothing. I just cannot understand it any thoughts
Steve
Earlier last month I replace the coil and ignition amp which cured the not starting issue but now it's back and I have flooded it plugs wet. It did try to cough into life at one point but now nothing. I just cannot understand it any thoughts
Steve
My experience last week suggests that even if you have a spark, you can't discount ignition problems. see:
http://www.pistonheads.com/gassing/topic.asp?h=0&a... starter
my coil was 18months old and has done less than 3000miles.
http://www.pistonheads.com/gassing/topic.asp?h=0&a... starter
my coil was 18months old and has done less than 3000miles.
Managed to get it going last night and used it today around 200 happy miles covered.
I think it was a combination of wet plugs took them out and dried them on the cooker, faulty king lead it looked suspect the teminal crimp loose inside the rubber boot. That with the damp and standing un used for so long I'm sure made the problem worse.
It started after cranking it over for longer than i would like. Made a nice change runnning the TVR for a day instead of the company Passat which failed its 1st mot on track rod ends and took two days to fix hence the urgency last night.
Anyway I'm going overhaul the whole ign system leads, distributor cap and rotor arm anybody know a good reasonably priced place ideally geniune parts? Not bothered about Magnecors though the land rover ones seem to have lasted long enough.
I think it was a combination of wet plugs took them out and dried them on the cooker, faulty king lead it looked suspect the teminal crimp loose inside the rubber boot. That with the damp and standing un used for so long I'm sure made the problem worse.
It started after cranking it over for longer than i would like. Made a nice change runnning the TVR for a day instead of the company Passat which failed its 1st mot on track rod ends and took two days to fix hence the urgency last night.
Anyway I'm going overhaul the whole ign system leads, distributor cap and rotor arm anybody know a good reasonably priced place ideally geniune parts? Not bothered about Magnecors though the land rover ones seem to have lasted long enough.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


