Mirror wiring
Mirror wiring
Author
Discussion

miniman

Original Poster:

30,239 posts

293 months

Sunday 22nd August 2010
quotequote all
Has anyone successfully managed to get access to the passenger mirror wiring without removing the door card? I want to run an extra wire up to the mirror housing.

Cider Andy

1,889 posts

256 months

Sunday 22nd August 2010
quotequote all
That will be difficult. It's so tight through the mirror boss that's bolted to the door, that you have to dismantle the connector to pull the wiring through.

You might fish a thin wire in from the top but it would involve removing the mirror casing. Even then you'll have limited space as you can't remove the back of the mirror casing without removing the entire assembly from the door.

If you can't do that you'll need to remove the whole assembly. It should screw straight out of the door but if it's been fitted for a while you might break the diecast aluminium frame.

I hate those mirrors. Bloody stupid design.

miniman

Original Poster:

30,239 posts

293 months

Sunday 22nd August 2010
quotequote all
Oh. Bugger. I feared as much, coupled with the cost and hassle of replacing one if it breaks. My plan was to fit an socket to hook the Accumate up to, I shall perhaps revert to my previous plan of running a feed out to the front bumper.

VictorMeldrew

8,293 posts

308 months

Wednesday 25th August 2010
quotequote all
miniman said:
Oh. Bugger. I feared as much, coupled with the cost and hassle of replacing one if it breaks. My plan was to fit an socket to hook the Accumate up to, I shall perhaps revert to my previous plan of running a feed out to the front bumper.
Can't you use the cigarette lighter?

miniman

Original Poster:

30,239 posts

293 months

Wednesday 25th August 2010
quotequote all
VictorMeldrew said:
miniman said:
Oh. Bugger. I feared as much, coupled with the cost and hassle of replacing one if it breaks. My plan was to fit an socket to hook the Accumate up to, I shall perhaps revert to my previous plan of running a feed out to the front bumper.
Can't you use the cigarette lighter?
I really want something that is (a) on the passenger side and (b) doesn't require the wire to exit through the window.

K4TRV

1,819 posts

283 months

Wednesday 25th August 2010
quotequote all
I put a cigar socket in the boot, near fuel inlet. Plug the charger in and close the boot!!

Useful for running electric pump to top up tyres when drivers side socket too far from near-side rear!!

HTH

Trev

mr shifty

249 posts

201 months

Wednesday 25th August 2010
quotequote all
You should be able to fish out the plugs which connect the mirror wiring to the feed from the loom if you remove the speaker easily enough without having to remove the door card.

Assuming you aren't that bothered about having a heated nearside mirror, would it be possible to disconnect the heated mirror wires and attach them to a cigarette lighter? That way you already have the wire installed and just need to worry about sorting out wiring from the door to the battery.

Edited by mr shifty on Wednesday 25th August 15:39