Seperating control arms from aluminum bearing housing
Seperating control arms from aluminum bearing housing
Author
Discussion

944fan

Original Poster:

4,962 posts

216 months

Wednesday 25th August 2010
quotequote all

After a lot of heating, grinding, whacking with BFH, swearing, and wrenching I have finally released the dreaded pinch bolt from my wheel bearing housing. smash Naturally the upper control arms are now royally censored

I have decided to replace the lot as there was a bit of play in one of the lowers too. However, I can't get the lower ball joints seperated as the only spliter I have doesn't open wide enough. I assume the aluminum parts are thicker. The Audi manual says to use the T40010 tool but I can't seem to find this available to buy in this country (only place I have found is in the states and with shipping it works out at about £160) or find a cheaper alternative. Even though I am replacing the arms I am loathed to smack them with a hammer.

Can anyone recommend one?

00161wj

566 posts

239 months

Wednesday 25th August 2010
quotequote all
Never used a tool. Just smash the housing with a big hammer, preferbly a copper one so it doesnt damage it too much.