Not starting Chim 400
Discussion
My Chim 400 is a bit buggered at the moment. It was working fine a couple of weeks ago, but whilst driving for the weekend she started messing around.
When I try to start her nothing happens. I'll run through the scenario:
Unlock doors with key fob (disarms immobiliser)
Check little red light on steering column is off and not flashing
Turn ignition on
Dashboard comes to life
Fuel pump primes
Turn to START
and then all I have is a little click from the passenger footwell. I've done the "lights on" check (from another thread), to see if they dim, no difference. I've given the underside of the dash a good thump to see if it's the immobiliser contacts (from another thread) and no difference. I've stuck jump leads on it, just in case it was a lack of battery power, nothing.
I do vaguely recall a slight electrical burning smell when stopped at some traffic lights, but dismissed it as it wasn't strong and I was next to a lorry (which can make all kinds of smells).
The car is now in my front garden waiting to go up on ramps (I'll need someone to help me bump start it so I can drive the bugger on first though).
Any ideas? I've read on here a lot about sticky starter solenoids etc, could it be that the mechanism hasn't come back down the shaft and stayed in contact with the ring gear? Therefore burning out the contacts/wiring? Just a dead starter?
All advice appreciated
When I try to start her nothing happens. I'll run through the scenario:
Unlock doors with key fob (disarms immobiliser)
Check little red light on steering column is off and not flashing
Turn ignition on
Dashboard comes to life
Fuel pump primes
Turn to START
and then all I have is a little click from the passenger footwell. I've done the "lights on" check (from another thread), to see if they dim, no difference. I've given the underside of the dash a good thump to see if it's the immobiliser contacts (from another thread) and no difference. I've stuck jump leads on it, just in case it was a lack of battery power, nothing.
I do vaguely recall a slight electrical burning smell when stopped at some traffic lights, but dismissed it as it wasn't strong and I was next to a lorry (which can make all kinds of smells).
The car is now in my front garden waiting to go up on ramps (I'll need someone to help me bump start it so I can drive the bugger on first though).
Any ideas? I've read on here a lot about sticky starter solenoids etc, could it be that the mechanism hasn't come back down the shaft and stayed in contact with the ring gear? Therefore burning out the contacts/wiring? Just a dead starter?
All advice appreciated

ButtonIt said:
Any ideas? I've read on here a lot about sticky starter solenoids etc, could it be that the mechanism hasn't come back down the shaft and stayed in contact with the ring gear? Therefore burning out the contacts/wiring? Just a dead starter?
All advice appreciated
If you're hearing a click then the starter solenoid is being switched, so don't think it's the immobiliser. Certainly sounds like a starter motor problem either sticking or possibly failed.All advice appreciated

They do suffer in the TVR with a lot of heat and they can breakdown. Straightforward enough to replace if you can get under the car. There are improved versions out there from various suppliers. Definitely worth doing the David Beer hot start mod while you are working on the car for longer term reliability.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff




I'll see if I can get the bugger started (bump) and up on the ramps. I'll get the multimeter out too, see if I can detec voltage at the starter.