maserati 3200 gt
Author
Discussion

jdman

Original Poster:

21 posts

214 months

Monday 30th August 2010
quotequote all
hi I have a 3200 gt auto and i went over a bump a week ago and check engine came on i switched the engine off and it reset but went over bump again today and same again but it wont reset even if i disconnect the battery for 30 mins. Is there any suggestions on how to find which sensor has gone faulty and i cant get it to a garage as im in Ireland no maserati dealers, is there a regular diagnostic system i can use to check it.


Allandwf

1,773 posts

226 months

Monday 30th August 2010
quotequote all
If it's a 2001 or newer car it should be OBD2 compliant,and a generic code reader should suffice, if not it's the dealers I'm afraid.

3200gt

2,727 posts

255 months

Tuesday 31st August 2010
quotequote all
jdman, YHM

jdman

Original Poster:

21 posts

214 months

Friday 3rd September 2010
quotequote all
i checked the lambda and cleaned them also the engine seems to have a good earth just a note if you turn the ignition on wait for all the lights to go out then wait another couple of seconds the check engine light comes on even without stating the engine any ideas.


AndrewW-G

11,968 posts

248 months

Friday 3rd September 2010
quotequote all
How old is the car? as there are a number of diagnostic options depending on age, IIRC the earlier cars still use the same heath robinson style box of LED's as the ghibli's did

jdman

Original Poster:

21 posts

214 months

Friday 3rd September 2010
quotequote all
its a 2000 gt if thats any help.

jd

jdman

Original Poster:

21 posts

214 months

Saturday 4th September 2010
quotequote all
after advice from warren aka 3200gt i disconnected the throttle pot cleaned the connections then went through the throttle pot reset error gone thanks again to 3200gt for the help and all others that pitched in.

jd

Contigo

3,141 posts

240 months

Tuesday 15th October 2013
quotequote all
Had exactly this one on mine. I assume you removed the throttle pot and cleaned it up using a wire brush?