Gasket Bolts Exhaust Manifold to Y-piece pre-serpentine ?
Gasket Bolts Exhaust Manifold to Y-piece pre-serpentine ?
Author
Discussion

piemanpaul

Original Poster:

32 posts

254 months

Wednesday 1st September 2010
quotequote all
I have a 1994 pre-serpentine Chimaera 4.3

I am wondering where to get my hand on replacement gaskets and bolts for the exhaust manifold to cat y-piece round flange connection (I think theres 8 bolts on the flange)


spend

12,581 posts

282 months

Wednesday 1st September 2010
quotequote all
The gaskets are TVR specials, be careful to get the right ones, there are 3 varieties IIRC, others were for Griffs only one on Chims AFIK. Very small and two larger 8 bolt patterns - ours are the largest of the 2, but I think some gaskets (and some flanges BTW) were made as dual purpose. JP used to have them so you may find that Tim at ACT has some.

The bolts are just UNF, can't remember size off hand but 5/16 or 3/8" I guess - compare them diameter wise to your manifold bolts (they are 3/8") if you are in a rush to find some.

Ant.

5,254 posts

312 months

Wednesday 1st September 2010
quotequote all
I dont use any gaskets on my manifold/y-piece flanges, just paste. As long as the faces are in good condition it should seal..