Refitting standard Y piece - Any Advice?
Discussion
Best method is a good ratchet strap across the manifolds to pull them in while you get the clamps on.... dont lean on the clamp fasteners too much as they snap like carrots.
In extremis, I have loosened off the header screws into the head, sorted the manifold to Y piece joint and then retightened the manifolds to head. Not for the feint hearted 'though and really an avoidable iteration of the horrible exhaust fastener routine that can be the cause of loads of grief when it all goes wrong.
In extremis, I have loosened off the header screws into the head, sorted the manifold to Y piece joint and then retightened the manifolds to head. Not for the feint hearted 'though and really an avoidable iteration of the horrible exhaust fastener routine that can be the cause of loads of grief when it all goes wrong.
Thanks for your reply.
I thought about the ratchet strap approach. I'll try this once I have a new clamp. I have only just tightened up the manifolds so don't really want to undo them again. As they go into the alloy head, I would have though this would be a weak point and possible cause of more damage.
Cheers
Liam
Pupp said:
dont lean on the clamp fasteners too much as they snap like carrots.
I've already found this bit our unfortunately, one snapped carrot!!I thought about the ratchet strap approach. I'll try this once I have a new clamp. I have only just tightened up the manifolds so don't really want to undo them again. As they go into the alloy head, I would have though this would be a weak point and possible cause of more damage.
Cheers
Liam
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


