Afternoon spent working on the chim
Discussion
Hi guys i have been putting it off for a while but finally decided to investigate the very slow operation of the drivers side window,also the drivers door had dropped again so that needed sorting. Anyway i managed to remove the doorcard and carpet, cleaned all the window runners and lubricated them with silicne spray, cleaned/regreased the window motor mechanism and all the electric connections, and the window works perfect now. With the doorcard etc removed i could finally get enough leverage to tighten the bolt on the top hinge properly, it was practcally immpossible just thru the speaker hatch, so now the door also shuts perfect. On the down side my forearm looks like a cats scratch post, becaus some of those nuts on the doorcard take some reaching! So if you have very slow or non working windows get the doorcards off and have a good look/clean/grease, you never know! thats all they might need.
[quote=haircutmike]Need to do my passenger window and the door cards don't seem too secure at the top.
What's the secret to remove the door cards?[/quote ]After removing the speaker, its just 3 no. nuts. 1st one as you look at the doorcard is to the front approx level at 9 o clock pos with the speaker hole. no"s 2 and 3 towards the bottom either side of the recess where the cig lighter/mirror switch is located. Finally remove the ash tray and there is a screw inside to undo, gently pull out from the bottom and push upwards, best to have the window lowered at this point. You have to undo the three wiring clips, mark which is which for reassembly and the doorcard is off. There are 4 no screws in the top of the carpet card, undo and remove, job complete.
What's the secret to remove the door cards?[/quote ]After removing the speaker, its just 3 no. nuts. 1st one as you look at the doorcard is to the front approx level at 9 o clock pos with the speaker hole. no"s 2 and 3 towards the bottom either side of the recess where the cig lighter/mirror switch is located. Finally remove the ash tray and there is a screw inside to undo, gently pull out from the bottom and push upwards, best to have the window lowered at this point. You have to undo the three wiring clips, mark which is which for reassembly and the doorcard is off. There are 4 no screws in the top of the carpet card, undo and remove, job complete.
Muke, take a look at this post. I did mine a while ago, and took some pics, hope they help. And.... dont for get the wing nuts for refitting!
http://www.pistonheads.co.uk/gassing/topic.asp?h=0...
http://www.pistonheads.co.uk/gassing/topic.asp?h=0...
Quick update.
Alex, (alexdaredevil) called round this evening to assist in door panel removal.
Before you could say pass me a spanner, he had the door panel off, took out the window rear runner, refixed the loose rubber channel, refixed the channel, replaced the missing motor mounting bolt, adjusted the window and refitted the panel!
I was a bit miffed as he left me to refix the speaker!
Window moves smoothly and my floppy door trim and rattly door are no more
.
Alex, come back, we haven't done the passenger door yet
.
Well done matey
.
Alex, (alexdaredevil) called round this evening to assist in door panel removal.
Before you could say pass me a spanner, he had the door panel off, took out the window rear runner, refixed the loose rubber channel, refixed the channel, replaced the missing motor mounting bolt, adjusted the window and refitted the panel!
I was a bit miffed as he left me to refix the speaker!
Window moves smoothly and my floppy door trim and rattly door are no more
.Alex, come back, we haven't done the passenger door yet
.Well done matey
.Gassing Station | Chimaera | Top of Page | What's New | My Stuff




