V8S Clean sheet
V8S Clean sheet
Author
Discussion

LamboV8S

Original Poster:

112 posts

195 months

Monday 6th September 2010
quotequote all
Hi all,
Been posting on the S series section but opinions re V8 engines are talk to you boys.
Right I am stripping a 91 S V8 completely for a full nut & bolt rebuild, not looking for massive power, just a hotter cam and port/match the heads a little, but where do I start with a new management system, what do you rate? it's 3.9 pre-cat. After the best reliable system.

Cheers

Ray

blitzracing

6,422 posts

251 months

Monday 6th September 2010
quotequote all
How much do you want to spend on ECU and ignition?

LamboV8S

Original Poster:

112 posts

195 months

Monday 6th September 2010
quotequote all
No idea? what's the choice?

Mark_S_24

405 posts

207 months

Monday 6th September 2010
quotequote all
Here's one they made earlier

http://www.lloydspecialistdevelopments.co.uk/Fully...

hope that gives you an idea
Mark

SILICONE KID

14,997 posts

262 months

Monday 6th September 2010
quotequote all
http://www.extraefi.co.uk/ I went down the Megasquirt route


LamboV8S

Original Poster:

112 posts

195 months

Tuesday 7th September 2010
quotequote all
Thanks chaps, so there's a fair bit of choice then, I will have a good look at both of these but it's going to be a bit yet before I get that far but I do like to have the knowledge up front, having a 'body lift party' on Saturday.

Cheers

Ray

blitzracing

6,422 posts

251 months

Tuesday 7th September 2010
quotequote all
To be honest the 14CUX is fine in non catalyst mode on near standard engines, its just the distributor and ignition thats falls short of the mark. There are significant gains to be made with mapped ignition and the fuel consumption under light engine loads. The 14CUX gets bad press on catalyst engines as it tries to hold the mixture leaner than really suits the RV8 at low speed that can lead to some snatching.