Russel Steel Braided Fuel Line
Russel Steel Braided Fuel Line
Author
Discussion

arthurr

Original Poster:

60 posts

271 months

Tuesday 30th March 2004
quotequote all
I just discovered after many dollars and alot of time that Russell Steel Braided Fuel Line is not up to the job. The line actaully weeps gas vapors. The garage smells aweful and I am going to have to rip out all the steel braid used for my fuel injection. The manufacturer tells me they have heard this complaint before but say nothing about it on their web site. The manufacturer also informed me that all steel braided lines do this regargless of the manufacturer.

Has anyone else had this problem? If so what did you do to overcome it, replace all the braided line with solid tubing?

margo

533 posts

270 months

Tuesday 30th March 2004
quotequote all
Genuine Aeroquip doesn't seem to have this problem. Teflon lined tubing is the real answer to modern fuels, but £££/$$$

gtrclive

4,193 posts

312 months

Tuesday 30th March 2004
quotequote all
Not if you buy it from Summit Racing in the states.

arthurr

Original Poster:

60 posts

271 months

Tuesday 30th March 2004
quotequote all
gtrclive

Have you had the same problem with Teflon hose? The hose I was using was not Teflon but was supposed to be for fuel applications.

steve_D

13,801 posts

287 months

Tuesday 30th March 2004
quotequote all
I wonder if that's why my garage smells.
Been looking all over to try and find the leak.
How did you identify it as the hose?
Steve

arthurr

Original Poster:

60 posts

271 months

Tuesday 30th March 2004
quotequote all
I purchased a combustable gas detector for $300 to figure it out. I dont know if you can rent these but they sure do work well.

arthurr

Original Poster:

60 posts

271 months

Tuesday 30th March 2004
quotequote all
More info:
It is a TIF8800 Combustible Gas Detector manufactured by Advanced Test Products an SPX company. Here is the URL www.professionalequipment.com/xq/ASP/ProductID.20/id.9/subid.104/qx/default.htm

steve_D

13,801 posts

287 months

Tuesday 30th March 2004
quotequote all
Will see if I can borrow one of those from work.
Will check to see if I can produce the same results.
Steve

steve_D

13,801 posts

287 months

Friday 2nd April 2004
quotequote all
Borrowed a detector from work and worked my way around the system. All bar one of the ali pipe joints showed no difference to the background level taken in the garage after it had aired for a while.

The upper transfer/balance pipe also shows no reading as the tanks are not full so there is no fuel in that pipe.
On all the other pipes the meter goes mad.

By far the highest reading is against the air filter so due to it's surface area it is probably that which is producing the bulk of the smell.

Steve

bigmack

553 posts

289 months

Friday 2nd April 2004
quotequote all
You've done the obvious by checking all the fittings it sounds. Have you smelled around the petrol tanks? I've had to repair my tanks twice due to stones getting wedged between the fiberglass and the bottom of the tank. Not a particularly difficult job, but not exactly fun either. Be sure to seal the tank off well.
I've very surprised that gas would smell so badly that it stinks up the garage due to Russel fuel lines. I've never noticed anything like this with rubber fuel lines on other vehicles.
Cheers!
-Mack