Rear lower wishbone cracked - replacement Q's
Discussion
Hey guys,
I have a crack in the rear drivers-side lower wishbone (I think thats right?) - the "brace" (in the apex of the tubing) where the droplink is bolted through...
I don't have a picture, but the flat "brace" is snapped 4/5s the way through - with only a tiny portion holding the brace together. The crack is right next to the droplink-hole, but does not actually pass right through it...
I have just upgraded the droplinks to Steve Heath rose-jointed one's, so I guess the extra force on the wishbone must have exploited a weakness in the brace and cracked it....
My questions are:
1. Should I replace the entire lower wishbone rather than repair it..?
2. Is replacing it a relatively simple operation - or is there more to it than one would think?
3. Will the car need to be re-geo'ed after the wishbone is replaced, or should the geometry be preserved?
Any info much appreciated,
Dom
I have a crack in the rear drivers-side lower wishbone (I think thats right?) - the "brace" (in the apex of the tubing) where the droplink is bolted through...
I don't have a picture, but the flat "brace" is snapped 4/5s the way through - with only a tiny portion holding the brace together. The crack is right next to the droplink-hole, but does not actually pass right through it...
I have just upgraded the droplinks to Steve Heath rose-jointed one's, so I guess the extra force on the wishbone must have exploited a weakness in the brace and cracked it....
My questions are:
1. Should I replace the entire lower wishbone rather than repair it..?
2. Is replacing it a relatively simple operation - or is there more to it than one would think?
3. Will the car need to be re-geo'ed after the wishbone is replaced, or should the geometry be preserved?
Any info much appreciated,
Dom
slideways said:
I had one of mine fail bought a mk2 replacement from adrian@ member on here got someone to weld it in the same place then painted it no geo required.
just to be clear thats the droplink mount not the whole wishbone
If its the same part that broke as Slideways i would go his route no question just to be clear thats the droplink mount not the whole wishbone
Edited by slideways on Wednesday 8th September 23:19

Colin RedGriff said:
Thanks - winging its way to me now..!Figure welding a new one in is probably better than welding the old one up...

Why are these braces so thin..? Surely something thicker is required, with all the force of the ARB pushing on it..?
Dom
Gassing Station | Chimaera | Top of Page | What's New | My Stuff




