EDIS8 question - SPOUT?
EDIS8 question - SPOUT?
Author
Discussion

Teetertank

Original Poster:

358 posts

218 months

Thursday 9th September 2010
quotequote all
Trying to identify the cabling from an EDIS8 module, and there are two grey 2-pin plug type things, each about 1" cube connected into the cut-off loom.

Can anyone explain what they do, and how they should be wired?

One is in-line with the SAW signal on pin-3, the other isn't connected to anything. Are they a coding plug of sorts?

Simon says

19,466 posts

252 months

Friday 10th September 2010
quotequote all
You don't need that block/resistor thingy Hugo i think that was called an octane plugs back in the day Vauxhall used something similar it was when UN-LEADED came into play you plugged in different spec one's to get the required retard,you just cut it off I am at work at the moment when I get home will post up a diagram for ya winkhttp://www.autosportlabs.net/Ford_EDIS_technical_i... the only ECU cables in shot you need is Pip & Saw and the screened/shield wire 7 the other wire IDM in that diagram going to the ECU shown you forget wink the EDIS tacho out is no use either for our cars smile all the other cables shown are used as in the OE application,this may interest you concerning EDIS too http://www.dainst.com/info/edis/edis.html i have loads of stored stuff concerning EDIS rolleyes this stuff was the quickest to hand.


Worth looking on here too Phil Ringwood in an Admin/Mod winkhttp://www.megamanual.com/forums.htm

EDITED FOR THIS


Edited by Simon says on Friday 10th September 23:19


Edited by Simon says on Friday 10th September 23:21