unstable car
unstable car
Author
Discussion

m4ckg

Original Poster:

625 posts

222 months

Thursday 9th September 2010
quotequote all
I've been out driving trying to scrub my new tyres in and found that on fast-ish bends the car seems very unstable, tyre pressure is ok, could this be the original suspension units or is it more likely to be some sort worn out bush ? thanks Scott.

p.s, didn't really have the confidence to push the car on the old tyres so I don't think its anything to do with the new tyres

spend

12,581 posts

282 months

Thursday 9th September 2010
quotequote all
Bounce the dampers/springs and get a bar on the bushes to see how they are. It isn't really rocket science, and even without a crystal ball I'd hazard a guess that your geometry may not be all it should be.


Alexdaredevilz

5,697 posts

210 months

Thursday 9th September 2010
quotequote all
Tyre pressures

m4ckg

Original Poster:

625 posts

222 months

Thursday 9th September 2010
quotequote all
I wondered if it was the shock absorbers?

Alexdaredevilz

5,697 posts

210 months

Thursday 9th September 2010
quotequote all
Check and double check the tyre pressures, 9/10 if it feels unstable there to high

m4ckg

Original Poster:

625 posts

222 months

Thursday 9th September 2010
quotequote all
Alexdaredevilz said:
Check and double check the tyre pressures, 9/10 if it feels unstable there to high
what is the correct pressure ? tyres were fitted Monday and I would have thought that they would set them to the correct pressure. The car is on 17" all round btw

slideways

4,101 posts

252 months

Thursday 9th September 2010
quotequote all
m4ckg said:
Alexdaredevilz said:
Check and double check the tyre pressures, 9/10 if it feels unstable there to high
what is the correct pressure ? tyres were fitted Monday and I would have thought that they would set them to the correct pressure. The car is on 17" all round btw
if you left it to a tyre monkey to set the pressures the pound to a pinch of st they will be far too high 22f/24r on standard wheels tyres not sure about 17's

Wildfire

9,951 posts

283 months

Thursday 9th September 2010
quotequote all
If you're running Toyo T-1R's then it will take 500 or so miles to scrub off the release agent. If not then check the pressures, then the geometry.

P400PLS

404 posts

258 months

Friday 10th September 2010
quotequote all
When tyres are fitted they can be inflated quite high to ensure they are correctly on the rims and the sealant has spread.

At least, that's what I was told once when I had new tyres and they were inflated to 35 psi. Felt horrible.

BliarOut

72,863 posts

270 months

Friday 10th September 2010
quotequote all
32 PSI will try to kill you yes

m4ckg

Original Poster:

625 posts

222 months

Friday 10th September 2010
quotequote all
does anybody know the correct pressure for the 17"s ?



Alexdaredevilz

5,697 posts

210 months

Friday 10th September 2010
quotequote all
Try 23F 25R see how that feels

Grey Ghost

4,614 posts

251 months

Friday 10th September 2010
quotequote all
Alexdaredevilz said:
Try 23F 25R see how that feels
Try this option or look at trying 25F and 27R which is what I currently run with 17" rims all round. It is all an experiment with each car and if the different pressure settings don't get it sorted take to a geometry specialist and see what they have to say.

Not wanting to state the obvious but set tyre pressures on cold tyres.

taylormj4

1,635 posts

297 months

Friday 10th September 2010
quotequote all
He's said the pressures are Ok.

What about front tracking ?

Cheers, Matt

Alexdaredevilz

5,697 posts

210 months

Friday 10th September 2010
quotequote all
taylormj4 said:
He's said the pressures are Ok.

What about front tracking ?

Cheers, Matt
Why would he ask what pressures to use then?

Pupp

13,044 posts

303 months

Friday 10th September 2010
quotequote all
Is it a full set replacement or just one axle, if so which? What makes/types are fitted?

Mixes can feel well odd and I have had experience of 15 and 16 inch Toyos being very affected when rears only were changed out. Apparently a few heat cycles can settle them down (and I guess the driver gets used to the changed response too)...

m4ckg

Original Poster:

625 posts

222 months

Friday 10th September 2010
quotequote all
Pupp said:
Is it a full set replacement or just one axle, if so which? What makes/types are fitted?

Mixes can feel well odd and I have had experience of 15 and 16 inch Toyos being very affected when rears only were changed out. Apparently a few heat cycles can settle them down (and I guess the driver gets used to the changed response too)...
A full set Of Toyo T1R's

storm grey

271 posts

213 months

Friday 10th September 2010
quotequote all
i put a new set of t1 rs on mine a wile ago when i first drove it the tyre pressures were to high .at 60 mph felt like driving on ice.tyre pressures now 24f 26r was up in blackpool last weekend at bng spoke to the lads from track v road about my high speed handeling they seemed a little concerned that i was on toyo t1 rs said they can take up to 1500 miles to scrub in probably done about 500 miles now i must admit that on the way home down the motorway the closer i was getting to home the better it felt.hope this helps.steve

m4ckg

Original Poster:

625 posts

222 months

Friday 10th September 2010
quotequote all
I think I've been a bit naive by thinking the tyre company would have set the pressure reasonably right. Just checked them with a proper tester and had nearly 40 psi on the rears and 32 psi on the fronts yikesgetmecoat

Colin L

1,243 posts

298 months

Friday 10th September 2010
quotequote all
Half your problem solved then.

I concur with the Toyo tyres, you need do need about 1000 miles to come good.

I was a bit unsure till I got half way to Blackpool last week. Now the grip is there and after the very fast run for the ferry on the way home they are just spot on.

Colin l