Air conn not working in Sagaris
Air conn not working in Sagaris
Author
Discussion

puckrup

Original Poster:

472 posts

229 months

Friday 10th September 2010
quotequote all
Have tried moving hot/cold control several times, no joy. System definitely under pressure, checked via charge point. No signs of leaking or green dye anywhere (Dye pack used during build) Clutch kicks in, revs drop slightly. No cooling effect whatsoever. CL is ON via POD menu

Airconn failed in last Sag about 6 weeks after I had it, same symptoms – turned out to be the trinary switch, can this be tested at all?

Any advice appreciated

Thanks

Neil

LeeT350c

575 posts

210 months

Friday 10th September 2010
quotequote all
If its charged and comp clutch kicks in does it run for around 20 seconds and fault or cut out?

If so I would suggest the expansion valve may have some st in it. You mention a rebuild, could some dirt / dust have got into the system?

JMO but here for help and advise.

Cheers

Lee

puckrup

Original Poster:

472 posts

229 months

Friday 10th September 2010
quotequote all
It doesn't trip out or stop running, keeps going, no fault code. Just no chilled air!

LeeT350c

575 posts

210 months

Friday 10th September 2010
quotequote all
hummmm with the fan up high is the airflow good out the vents? if so has the flap come off??

Edited by LeeT350c on Friday 10th September 19:16

mrleigh1

7 posts

192 months

Sunday 12th September 2010
quotequote all
i had the same prob turned out to be the trinity switch this also led to a 30 amp fuse being blown which i was told (by the garage), was the reason for the radiator fans not working.
Since a new switch and re-gas i still get a/c fault 147 but it works fine as does the fans. smile