Discussion
SILICONE KID said:
Can you buy the flexible part and have it welded on,Don`t fancy getting a new exhaust


Yes - I did just that some months ago. I think its called flexi hose, it's not that easy to find on the web. Apparently you can get it replaced in stainless hose, but I spent a long time searching and never found any in the right size.


If you take it to an exhaust place they should be able to order in the bit if you can't source it.
In the interim, a baked bean can is the perfect size to sleeve it with some jubilee clips.
Well you should look harder!
What size do you need?
https://www.jetex.co.uk/jetex/store/index.php?_a=v...
https://www.jetex.co.uk/jetex/store/index.php?_a=v...
What size do you need?
https://www.jetex.co.uk/jetex/store/index.php?_a=v...
https://www.jetex.co.uk/jetex/store/index.php?_a=v...
Teetertank said:
I tried exactly the type you posted the links for. Nice as they are, the braided outer section makes it too fat too fit - the bell housing won't allow it. Size is around 73mm
If anyone made it fit, would like to know- as I still have one of those sections sitting unused.
Ill have a look tomorrow a bit moreIf anyone made it fit, would like to know- as I still have one of those sections sitting unused.
Tried the states?
Daren, the 5 litre had the flexible bit in the exhaust as standard.i quess more flexing was expected in the exhaust due to the greater power.JP exhausts in Macclesfield made the original exhaust so when mine went,they kindly made me a new piece which was welded back,very helpful people.
i made a small mod by welding a thin piece of stell over this section,welded at the front only which acts as a scrap barrier.
www.jpexhausts.co.uk 01625619916 there are two sizes so measure it before you ring them
i made a small mod by welding a thin piece of stell over this section,welded at the front only which acts as a scrap barrier.
www.jpexhausts.co.uk 01625619916 there are two sizes so measure it before you ring them
Edited by markreilly on Monday 13th September 10:17
markreilly said:
i made a small mod by welding a thin piece of stell over this section,welded at the front only which acts as a scrap barrier.
Definitely a good idea. If you usually encounter lots of speed bumps then some extra protection should be useful. I noticed that the flexible section on mine lasted only one year. It’s the only non stainless part of the exhaust that can contact the ground, and certainly the weeakest part. Flexible section is only found on 5.0 cars - doubt it would hurt much to replace with a solid piece though.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff



