Discussion
Firstly this is my first post so hello all.
Right I have a VW Lupo 1.4 16v running 120bhp.
I have uprated manifold, full exhaust system, air filter and suspension.
I'm looking to turbo charge her to try get her running about 160-170bhp.
I just want to know if anyone knows how much the internal's can take before having to forge and so on.
Advise/comments would be great.
Cheers
Right I have a VW Lupo 1.4 16v running 120bhp.
I have uprated manifold, full exhaust system, air filter and suspension.
I'm looking to turbo charge her to try get her running about 160-170bhp.
I just want to know if anyone knows how much the internal's can take before having to forge and so on.
Advise/comments would be great.
Cheers
hello,
the crucial thing to consider is how much boast you want to run when deciding if you need forged internals. I know of a couple of lupos with Eaton superchargers on them running 6-8psi depending on pulley size on stock insides but with a headgasket spacer to reduce the compression. These are wacking out the 160+ hp that you desire.
The advantage of the supercharger is that it can sit and the front of the engine bay although it will requre the front slam panel to be trimmed and the pulley allignment needs to be 100% accurate. Once you have the charger, intercooler an pipework in place your next hurdle will be management, Emerarald/Megasquirt/DTA are the sort of things you will end up with. I have heard of people with GTIs running piggyback Ecu chips but not always with great success.
Its a lot more work but have you considered a G40 or 20VT conversion?
dave
the crucial thing to consider is how much boast you want to run when deciding if you need forged internals. I know of a couple of lupos with Eaton superchargers on them running 6-8psi depending on pulley size on stock insides but with a headgasket spacer to reduce the compression. These are wacking out the 160+ hp that you desire.
The advantage of the supercharger is that it can sit and the front of the engine bay although it will requre the front slam panel to be trimmed and the pulley allignment needs to be 100% accurate. Once you have the charger, intercooler an pipework in place your next hurdle will be management, Emerarald/Megasquirt/DTA are the sort of things you will end up with. I have heard of people with GTIs running piggyback Ecu chips but not always with great success.
Its a lot more work but have you considered a G40 or 20VT conversion?
dave
20Vt will no doubt cost you less in the long run as there are off the shelf wiring harnesses and conversion parts available plus you have a block/internals designed to take forced induction rather than trying to modify your 1.6.
Badger5 motorsportl, Jabba sport or JBS autos would be people to contact regarding 20vt into lupos as i believe they have all built them. The badger5 car lives near me and is a very good conversion, the car almost seems factory.
dave
Badger5 motorsportl, Jabba sport or JBS autos would be people to contact regarding 20vt into lupos as i believe they have all built them. The badger5 car lives near me and is a very good conversion, the car almost seems factory.
dave
Gassing Station | Audi, Seat, Skoda & VW | Top of Page | What's New | My Stuff



