Key fob not working. Reset?
Key fob not working. Reset?
Author
Discussion

grand-one

Original Poster:

178 posts

286 months

Thursday 16th September 2010
quotequote all
Is there a way to reset a keyfob? I have a 1995 Chimaera with the original Meta alarm immobiliser unit and the seperate key and keyfob. After suffering a flat battery on the car, only one of the 2 sets of keyfobs now works. I have replaced the batteries in the keyfob too but still no luck. Checked the Bible but that suggests going to a TVR dealer......

roseytvr

1,790 posts

209 months

Thursday 16th September 2010
quotequote all
Try discounecting the battery again and on reconnection stick the key in the alarm control thinging and press the buttons on the fob. Seemed to work on mine when I had a similar problem

Stiggly

33 posts

195 months

Friday 17th September 2010
quotequote all
I've got the old type keyfob with two buttons. Disconnecting the battery negative terminal actually resulted in totally and permanently disabling the immobiliser and central locking, which as it happens was exactly what I wanted to do at the time. All subsequent attempts to 're-activate'the key fob have been unsuccessful. I've been advised by everyone that if I want an alarm / immobiliser, I should get a decent new one fitted.

paulathome

686 posts

249 months

Saturday 18th September 2010
quotequote all
Stiggly, I would do the same again, disconnect your main battery but on reconnection do it smartly and cleanly without any fiddling once the connection is made. Sometimes if you get several connections and disconnections as you fit the battery terminal it can cause the Micro in the alarm to hang and not run correctly. It has happened a couple of times on mine and also when the battery had run almost flat.
Good luck.
Paul.