Cold water on my foot
Discussion
Left hand drive car.
I took a right bend and got a wet foot.
I was testing my AC, which works ok and just manages to combat the heat from the tunnel
.
It appears the drain below the evaporator is blocked, quite common.
However, the diagram does not show a drain, nor does it show a hose.
I cannot believe anybody would design an AC system without a drain.
Before I get under the car with an air hose to search for it can anyone confirm it has one please. Which side it hangs down would be useful too.
Cheers
I took a right bend and got a wet foot.
I was testing my AC, which works ok and just manages to combat the heat from the tunnel
.It appears the drain below the evaporator is blocked, quite common.
However, the diagram does not show a drain, nor does it show a hose.
I cannot believe anybody would design an AC system without a drain.
Before I get under the car with an air hose to search for it can anyone confirm it has one please. Which side it hangs down would be useful too.
Cheers
jeff m said:
I cannot believe anybody would design an AC system without a drain.
Cheers
The AC designer probably didn't. But then TVR got hold of it... Cheers

I dunno, all this recent talk of headlamp washers and air conditioning, are Wedge owners going soft or what? I was just thinking about this the other day, as I was honking along with the cruise control set at 90...

Jeff..please..dont go anywhere near that tin of glue...Try this with it first.. 2 x small squares(2") of ply or thin veneer scrap.. use a fine medium bristle brush..1/4" to 1/2" will do..now saturate the brush and apply like you would gloss paint spreading any areas that are more saturated..do this to one side of each bit of wood..leave it to dry for 5-10mins or untill it is touch dry,slightly tacky.. now press the wood together,clamp or tape..done.. if you have it squidging out the sides then you have used too much homes..Its no good if you cant apply it to both surfaces..Spray contact adhesive is sometime better used for jobs like roof linnings as the tack is lower at the start which allows for small movement when fitting..Paint on contact is more suited for carpet or fascias as it provides an extra grip when you match the two surfaces together..errors are less forgiving though.
Hi andy..did you know that you can go 10mph over the speed limit and the cameras wont flash(most of em) the newer ones are more accurate though.. Perhaps the misses is having one over on ya..naughty..naughty..You could always pop the speedo cable off cos us men know how fast were going...

Wedg1e said:
jeff m said:
I cannot believe anybody would design an AC system without a drain.
Cheers
The AC designer probably didn't. But then TVR got hold of it... Cheers


Any Taz racers about?
I'm sure they have the box for the matrix and evaperator laying on their garage floor.
Does it have an extra hole lower left or right (or at all)
Grady said:
Probably reversed for the home market. Grady
You would think 
When I first attended Woodwork, (before I had working AC) I asked a quite a few Wedge owners whether they had AC and what they did to make it work like a proper car.
Most answered their AC did not work whislt giving me look that said "Why did you ask me that in front of other people"
Stopped asking as it definately irritated people.
BTW Mine is ok on a 90+ day, but not a testicle nummer

Gassing Station | Wedges | Top of Page | What's New | My Stuff






