Once again Tame Technician, I need some help with my A3
Discussion
So, at 5am this morning the missus needed taking to the airport for a business trip to Germany. "no worries darling, we'll take the audi as its far more comfortable than the fiesta". And that's where it all went wrong....
Drove about 100 yards away from our house and the engine management light came on and the engine started to vibrate/shudder. By this point we were in a 1 way system, the end of which was only about a half mile trip back to our house so thought nothing of it and decided we should swap cars. Another 100 yards down the road and the vibration/shudder became alot more violent and the engine wouldn't rev beyond 2000rpm. Limped the car home, swapped cars, drove to the airport, got to work stupidly early, slept in reception et al.
The car is an '05 plate 3.2 quattro (roughly 60,000 miles), I have 'borrowed' a Bosch fault reader from work and pulled the codes:
'P0014 camshaft retard (bank 1)
target value not attained'
'P0300 combustion failure detected
Maximum exceeded'
'P0303 combustion failure cylinder 2 detected'
To me, this screams coil pack failure, and the other fault codes relate to the fact the engine has tried to compensate for the poor combustion caused by the coil pack failure, and simply can't.
Any help or further diagnostic work I should do would be thoroughly appreciated!
Drove about 100 yards away from our house and the engine management light came on and the engine started to vibrate/shudder. By this point we were in a 1 way system, the end of which was only about a half mile trip back to our house so thought nothing of it and decided we should swap cars. Another 100 yards down the road and the vibration/shudder became alot more violent and the engine wouldn't rev beyond 2000rpm. Limped the car home, swapped cars, drove to the airport, got to work stupidly early, slept in reception et al.
The car is an '05 plate 3.2 quattro (roughly 60,000 miles), I have 'borrowed' a Bosch fault reader from work and pulled the codes:
'P0014 camshaft retard (bank 1)
target value not attained'
'P0300 combustion failure detected
Maximum exceeded'
'P0303 combustion failure cylinder 2 detected'
To me, this screams coil pack failure, and the other fault codes relate to the fact the engine has tried to compensate for the poor combustion caused by the coil pack failure, and simply can't.
Any help or further diagnostic work I should do would be thoroughly appreciated!
Change the coil on number 2 and clear the codes, then re test the car.
The first vibration you mention sounds to me like a misire on one cylinder. Add to that you have codes that confirm there has been a misfire and isolates cylinder 2.
HOWEVER, this does not explain the more servear vibration you had or the inability to rev over 2000rpm. I dont want to speculate as to what this might be, dont want to scare you, as it could simply be spirious and cause by the original misfire fault.
The first vibration you mention sounds to me like a misire on one cylinder. Add to that you have codes that confirm there has been a misfire and isolates cylinder 2.
HOWEVER, this does not explain the more servear vibration you had or the inability to rev over 2000rpm. I dont want to speculate as to what this might be, dont want to scare you, as it could simply be spirious and cause by the original misfire fault.
Gassing Station | Audi, Seat, Skoda & VW | Top of Page | What's New | My Stuff


