Chim will not start...likely causes?
Chim will not start...likely causes?
Author
Discussion

Pepsi_x

Original Poster:

217 posts

296 months

Friday 24th September 2010
quotequote all
Hi guys,

OK I know that's a little vague. I used the car on Wednesday everything was normal. Tried to start the car last night and nothing happened!

The battery is fine and fully charged, all the lights, dashboard etc are fine, the fuel pump kicks in, but when I turn the key, absolutely nothing happens. There's no engine turnover, there's not click from the starter.

So what are the most likely causes, as I will have to call the RAC out, who will hopefully tow me to TVR Power, but if its something really simple they may of course be able to fix it there and then, yes probably wishfull thinking but hey..!

My first thought is its the starter motor, but don't they tend to fail gradually over time, this seems to have happened over night?

ta
James

pwd95

8,459 posts

269 months

Friday 24th September 2010
quotequote all
Try giving it a gentle tap with a hammer. Might be jammed.

Pupp

13,043 posts

303 months

Friday 24th September 2010
quotequote all
Sounds like the immobiliser.... search on here for 'hot start', well known issue (and the car doesn't need to be hot to be afflicted)

Mad as it sounds, worth giving the dash top in front of the passenger seat a really sharp slap (this is where the immobiliser is stowed) as it has been known to restore service

Mark_S_24

405 posts

207 months

Friday 24th September 2010
quotequote all
Mine did that, it was the Starter Motor.
The Selector arm (or whatever it's proper name is) must have stuck in the wrong place.
It jumped into life the the smallest of bump starts, and it's never happened again.

HTH

Mark

Pepsi_x

Original Poster:

217 posts

296 months

Friday 24th September 2010
quotequote all
OK maybe I'll try giving it a tap first before calling the RAC man.

Silly question, but where is the starter motor, I'll be honest, I haven't got a clue what I'd be looking for....

ta
James

sgrimshaw

7,587 posts

281 months

Friday 24th September 2010
quotequote all
Safer to let RAC man give it a professional tap, it's what you pay your membership for !

lmagDM

13 posts

194 months

Saturday 25th September 2010
quotequote all
I suggest checking fuses. I had a similar non-start problem and found a blown ignition circuit fuse. Its a simple check. Look for fuse panel in passenger footwell behind the battery.

teamrecon

154 posts

220 months

Saturday 25th September 2010
quotequote all
Check the terminals on the iginition coil. Had the same problem last week, one of the terminal spade connectors had spread and come off !!

Squeezed the spade connector together and reconnected to coil. Started immediately..

Pupp

13,043 posts

303 months

Saturday 25th September 2010
quotequote all
teamrecon said:
Check the terminals on the iginition coil. Had the same problem last week, one of the terminal spade connectors had spread and come off !!

Squeezed the spade connector together and reconnected to coil. Started immediately..
The OP described no engine turn-over. A coil lead off will not prevent the starter turning...

teamrecon

154 posts

220 months

Saturday 25th September 2010
quotequote all
Pupp said:
teamrecon said:
Check the terminals on the iginition coil. Had the same problem last week, one of the terminal spade connectors had spread and come off !!

Squeezed the spade connector together and reconnected to coil. Started immediately..
The OP described no engine turn-over. A coil lead off will not prevent the starter turning...
Oh ok I stand corrected. I had the same symptoms as the op and this cured me, no starter motor for me either ?

Kitchski

6,552 posts

262 months

Saturday 25th September 2010
quotequote all
I'm going immobiliser or ignition switch.

Pepsi_x

Original Poster:

217 posts

296 months

Monday 27th September 2010
quotequote all
Morning all,

Thanks for all the advice...however when I got home on Friday I thought I'd go looking for the start motor but decided to try and start it one last time....and guess what...it fired up first time, no problem! Didnt need to hit the starter motor, slap the dashboard or anything lol...

Go figure huh!

I suspect it's starter motor problems though, as a few times over the weekend there has been a second or two delay between turning the key and the engine firing up. I guess it's something to add to the list for the next service...

Thanks everyone smile