A4 1.8 Oil drain bolt. Arrrgghhhh!
A4 1.8 Oil drain bolt. Arrrgghhhh!
Author
Discussion

cod man

Original Poster:

513 posts

226 months

Friday 24th September 2010
quotequote all
I decided to change the oil in my Audi A4 1.8 today, but I cannot get the drain plug undone. It seems well and truely rounded off now too. I knew it was a bit dodgy, and I have a new one ready to replace it. Any advice on getting the old one off would be greatly appreciated!

944fan

4,962 posts

216 months

Friday 24th September 2010
quotequote all
I can't understand how it can be so tight that it didn't crack the sump, unless it has siezed in. Strange. Anyway, try using a 6 point socket if you havent already, this will grip better than a standard 12 point. If it is badly rounded try getting a slightly smaller imperial socket on it, you might need to tap it on with a hammer. Use a breaker bar but go slowly, you don't want to round it off any more. You could also try an impact wrench if you have access to one.

The other option is to weld another nut to it.

Dr G

16,009 posts

273 months

Friday 24th September 2010
quotequote all
Self adjusting pipe wrench, will apply as much torque to a rounded bolt as your arm will!

http://www.amazon.co.uk/Rolson-Tools-18560-Adjusti...

But obviously available slightly less huge, this was just a handy link. Basically a Stilson with a spring so that the harder you pull the harder it grips.

cod man

Original Poster:

513 posts

226 months

Friday 24th September 2010
quotequote all
Thanks for the advice. I'll give at another go tomorrow.

Mojocvh

16,837 posts

293 months