Mixed up HT leads
Mixed up HT leads
Author
Discussion

Dungman

Original Poster:

316 posts

202 months

Sunday 26th September 2010
quotequote all
Called out a very well known recovery firm on Friday due to a flat battery and foolishly left the bloke alone with my car. To cut a very long and depressing story short the car still would not fire with a jump start and he decided to check the spark plugs. Knock at the door 15mins later to say " Er, I can only get 7 of the plugs to go back in and i've no idea which ht lead goes to which plug ". I told him to leave.

So now I still have a flat battery, have to refit the plugs and no idea which HT lead is which.

Any advice on how sort the leads out much appreciated. Searched the forum to no avail.

Cheers



Dave 500

7,889 posts

273 months

Sunday 26th September 2010
quotequote all


smile

scotty_d

6,795 posts

225 months

Sunday 26th September 2010
quotequote all
Dave 500 said:


smile
A good guide but i would check TDC, My dizzy turned out to be a notch out from this diagram.

Edited by scotty_d on Sunday 26th September 13:34

Barkychoc

7,848 posts

235 months

Sunday 26th September 2010
quotequote all
Distributor may not be as per the pic - the firing order is correct but you may need to work out which is cylinder 1.

Take No1 spark plug out & turn engine over with a socket / bar with your finger over the spark plug hole until you feel the pressure building, then look at the timing marks and continue to turn it till they are at TDC.
The rotor arm will now be pointing at cylinder 1.

If you don't have the right socket it can be done with the car in 5th gear & handbrake off & pushing it to turn the engine, it's not very elegant though irked

Edited by Barkychoc on Sunday 26th September 13:39

Dungman

Original Poster:

316 posts

202 months

Sunday 26th September 2010
quotequote all
Thanks everyone. I knew the rear plugs on both banks hadn't been disturbed and matched the diagram from Dave 500. Went with that and back to rude health.bow