Fuel Pump Primes, but nothing when key is turned
Discussion
Had issues last night after i had returned to the car after aquick pint! unlocked the car, turned the key all lit up and pump primed but that was it.
AA where as much use as a choclate condom they said there was definately power at the starter, but i have checked and there is no power there now.
Does the immobiliser immobilise the starter?
Any Ideas greatly recieved
cheers Mark
AA where as much use as a choclate condom they said there was definately power at the starter, but i have checked and there is no power there now.
Does the immobiliser immobilise the starter?
Any Ideas greatly recieved
cheers Mark
Edited by Milky400 on Wednesday 29th September 11:22
I think that what I described above as the ignition circuit is actually the starter circuit
I am at work at the moment so I haven't got access to all my notes to check.
The wire for the starter circuit as I remember is white with red trace (White/Red)
There are a few places to check for power to the start circuit.
1. At the back of the ignition switch(in start Position)
2. At the connector block to the immobiliser
3. At the starter solenoid terminal.
The test at the connector block to the immobiliser will tell you if you have an immobiliser problem.
If you need more details I can PM you but I don't think it's a good idea to post more detailed info than I have.
I am at work at the moment so I haven't got access to all my notes to check.
The wire for the starter circuit as I remember is white with red trace (White/Red)
There are a few places to check for power to the start circuit.
1. At the back of the ignition switch(in start Position)
2. At the connector block to the immobiliser
3. At the starter solenoid terminal.
The test at the connector block to the immobiliser will tell you if you have an immobiliser problem.
If you need more details I can PM you but I don't think it's a good idea to post more detailed info than I have.
From my experience it could be the 'hot start' problem (perhaps just the fuse in the hot start kit if one has already been fitted), the starter motor needing a gentle tap with a hammer or the car rocking whilst in gear, or a failing ignition switch - or perhaps all three!
If it was the immobiliser the fuel pump wouldn't kick in.
If it was the immobiliser the fuel pump wouldn't kick in.
Yes the immobilizer cuts power to the starter solenoid.
As mentioned earlier just stick +12v to the spade terminal on the starter and the starter should fire up (easy to make up a 20A push switch linking the starter to the alternator pole to check).
Fuel pump is normal, controlled by the ECU it first primes and then has a break until the ECU sees starting rpm's.
As mentioned earlier just stick +12v to the spade terminal on the starter and the starter should fire up (easy to make up a 20A push switch linking the starter to the alternator pole to check).
Fuel pump is normal, controlled by the ECU it first primes and then has a break until the ECU sees starting rpm's.
I have a similar issue - any thoughts to this one.
This only seems to happen once i've used the car (so it's warm) and I've stopped with engine off. I've had the 'hot start' mod fitted (about 6 months back now) as I was experiencing it almost all the time and it fixed it straight off - so happy motoring! However in the last 2 months the following has started to happen and its intermitent too.
When I turn the ignotion key, the fuel pump kicks in but no start up. However if I hold the key in the "ignition fire" position and keep it held thers, after about 20 - 30 seconds it fires up and I'm good to go.
I'm at a lost as to why holding the key this way for such a long time works.
Any ideas?
This only seems to happen once i've used the car (so it's warm) and I've stopped with engine off. I've had the 'hot start' mod fitted (about 6 months back now) as I was experiencing it almost all the time and it fixed it straight off - so happy motoring! However in the last 2 months the following has started to happen and its intermitent too.
When I turn the ignotion key, the fuel pump kicks in but no start up. However if I hold the key in the "ignition fire" position and keep it held thers, after about 20 - 30 seconds it fires up and I'm good to go.
I'm at a lost as to why holding the key this way for such a long time works.
Any ideas?
spend said:
That sounds like the ignition switch itself 'burnt out' - check the spade terms on the back of the switch to start with (but TBH a new switch on hand is probably easier once you've got that far?)
cheers - I assume its the standard vauxhall part that's listed on the Chimaera pages.mgjc said:
cheers - I assume its the standard vauxhall part that's listed on the Chimaera pages.
Vauxhall part No. 90052497 is for the ignition switch only (not the lock barrel). I got one a couple of weeks ago. Less than £20 from my local Vauxhall dealer. You can get one much cheaper from an online Vauxhall spares place.I had a similar problem, fuel pump primed, turned ignition key & nothing happened. It only used to happen when the car was hot. Leave it a few minutes to cool down & the car started fine...
I bought the hot start mod & fitted, no more problems for a couple of months & then it started happening again when the car was cold.
When I punched the underside of the dash on the passenger side of the car, the car started (this is where the immobiliser sits). This was freeing up the sticking immobiliser relay...
I spoke to Carl Baker who diagnosed it as a faulty immobiliser over the phone & the hot start kit had done nothing but mask the real problem, which was the immobiliser all along. Popped down to Carls & had a new immobiler fitted, no more problems since :-)
I bought the hot start mod & fitted, no more problems for a couple of months & then it started happening again when the car was cold.
When I punched the underside of the dash on the passenger side of the car, the car started (this is where the immobiliser sits). This was freeing up the sticking immobiliser relay...
I spoke to Carl Baker who diagnosed it as a faulty immobiliser over the phone & the hot start kit had done nothing but mask the real problem, which was the immobiliser all along. Popped down to Carls & had a new immobiler fitted, no more problems since :-)
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


