MK2 Golf GTI 16V engine rebuild
MK2 Golf GTI 16V engine rebuild
Author
Discussion

Andy OH

Original Poster:

1,961 posts

281 months

Thursday 30th September 2010
quotequote all
Chaps,

I'm looking for some leads or contacts for garages or specialists you could recommend to rebuild a standard MK2 Golf GTI 16V engine and also have the gearbox rebuilt.

I don't really want an uprated engine as I want to keep the car as close to standard as possible and I want to retain the original engine number etc.

I recently bought a 1991 oak green MK2 16V which only had one owner from new and a full VWSH but has done 250K miles on the original engine and gearbox. Now nothing has happened but I would apprecaite some contacts if you can.

Ideally I'd like to use someone in the south east, I'm based on the Herts/Essex borders, but would obviously consider further a field if someone is highly recommended.

I appreciate this is a 19 year old Golf but it is quite unique in ownership terms and history and it is a car I am never going to sell.

Thanks.




Edited by Andy OH on Thursday 30th September 13:02

Dr G

16,010 posts

273 months

Thursday 30th September 2010
quotequote all
BR Motorsport did mine but a quick google gives the impression that they are no more frown

You've got people like Stealth Racing, The Phirm, Voodoo motorsport who all deal with old veedubs on a daily basis and are all SE based.

Andy OH

Original Poster:

1,961 posts

281 months

Thursday 30th September 2010
quotequote all
Dr G,

I called BR Motorsport, they still exist but do not do this type of work any longer and they said they haven't for the past ten years.

However, I had a very positive conversation with Voodoo Motorsport and the are not that far away from me. They are obviously very busy as they do not have a slot for a job like this until next July.

I will take a visit over there before I committ to having the work done by them as I have been burnt quite badly before when I had some engine work for an E30 M3 carried out by what turned out to be an absoulte wcensoredr of an engine builder which almost ended up in court.

Thanks for the recommendations.



Edited by Andy OH on Thursday 30th September 15:01

aka_kerrly

12,506 posts

241 months

Thursday 30th September 2010
quotequote all
what kind of work are you thinking of having done and what is the engine like now? does it smoke or burn/use oil?

When i rebuilt mine i went for:

Head
new inlet and exhaust valves
8 new exhaust valve guides
tripple cut valves
new valve stem seals
mild porting/polishing of the inlet/exhaust ports
new cam chain
skimmed 40tho ( the head had never been skimmed before so we took a little extra off to raise the compression)

That lot set me back just under £300 as i didnt do all the work

Block
decked block
new oil pump
new water pump
oilways an coolant channels cleaned out - remove blanks on block to gain access
new oil pick up pipe
MK3 ABF headgasket kit with tripple layer steel gasket
new headbolts
cambelt kit + tensioner + all belts+pulleys

again this was about £200 parts

A set of piston rings will set you back another £80 in parts, something i didnt have done at the time which would have been a good plan but oh well.

nearly all my parts came from carpartsonline.co.uk or VW.


Andy OH

Original Poster:

1,961 posts

281 months

Friday 1st October 2010
quotequote all
The engine doesn't smoke, it burns a little oil but nothing dramaticand I regularly check the oil level (literally before every drive) it doesn't get driven that much. I'm only thinking about a rebuild as it has done 250K miles and as I am never selling it I would like it to last for many more years, however, the engine may be ok for the little use it now gets, but I don't mind spending money on it should it need to be done.


aka_kerrly

12,506 posts

241 months

Friday 1st October 2010
quotequote all
I see, in which case id suggest a compression test, oil pressure test (2bar at 2k revs when hot) analysis of the CO2 and a dyno run to get an idea of how healthy the engine is. Then you are probably better off leaving it be but doing some preventative maintenance.

Essentially it's more a task of ensuring the engines lubrication, cooling systems, the timing/ignition/fueling are all set fine and in good working order and your engine will continue for many more miles. There are 16v engines on over 300k!

dave


Andy OH

Original Poster:

1,961 posts

281 months

Friday 1st October 2010
quotequote all
Dave, many thanks for your advice. I'll get these checked and go from there.