Took the Chim to the dyno today (do not read chimaera1855)
Discussion
After I thought I cooked my engine with the water coming out after the last incident, I decided to take my Chim to Surrey rolling road(thanks VIXYP!!)
so I could see how its running and if I had done any damage,
I was sweating buckets and very nervous
Heres some bad pics of the run, and im very happy of the out come
Only mods are pre cats drilled out, Standard 400 every else??
Theres suspicion its either a 4.0HC, modded 400 or even a 4.5 I will investigate more soon
I see its running abit rich, so im planning a Y-piece decat and smooth bore pipe and maybe some carbon trumpets to see me abit closer to 300
Thanks to Surrey rolling road for fitting me in with in the hour :-)
Alex


so I could see how its running and if I had done any damage,
I was sweating buckets and very nervous
Heres some bad pics of the run, and im very happy of the out come
Only mods are pre cats drilled out, Standard 400 every else??
Theres suspicion its either a 4.0HC, modded 400 or even a 4.5 I will investigate more soon
I see its running abit rich, so im planning a Y-piece decat and smooth bore pipe and maybe some carbon trumpets to see me abit closer to 300
Thanks to Surrey rolling road for fitting me in with in the hour :-)
Alex


Edited by Alexdaredevilz on Thursday 30th September 20:40
Alexdaredevilz said:
Any luck?
As im very curious
Alex
Sorry didnt get back last night, that engine number is the original one, if it has been done by more the engine number will be different on the block.As im very curious
Alex
But when tuning a n/a engine the only one thing that will add torque across the whole rev range is an increase in capacity, heads exhausts cams induction etc... will hopefully increase torque but only in certain areas of the rev range, lose at the bottom gain at the top etc.. with yours making that much torque i would lay money on it being a 4.6
chimaera1855 said:
to be honest been waiting for the past 2 months for scPOWER to finish my kit.so i guess for xmas ahahah
From what you are saying you have ordered the scPOWER kit. If this is the case and it is in manufacture how can you consider now changing your engine to a 4,5L or 5L.At best the kit will fit your new engine, but will not be set up to get the best out of the larger capacity.
After another dyno run you will then be complaining that you sc 5L is making less that a std 5L
I think that YOU are the problem, not your car
IMHO
Andy
Gassing Station | Chimaera | Top of Page | What's New | My Stuff



t i did read it ahahaha.dont worry i ll get that number and more soon ahaha



