Erratic Oil Pressure
Discussion
Took my car for a drive AJP and found that even though the oil level is ok, pressure sometimes erratically drops from 60psi to 10psi or so running.
At standstill idle it drops from 30psi to zero.. Thought it could be a gauge problem or sender problem, where can I find the sender?
Cheers
Steve
At standstill idle it drops from 30psi to zero.. Thought it could be a gauge problem or sender problem, where can I find the sender?
Cheers
Steve
It could be the oil pressure relief valve spring has nearly had it.
Id check it asap, because if it breaks it will wreck the engine.
You have to get under the car and remove the big nut on the side of the oil pump and its in there.
http://www.clever-trevor.net/part/477/oil-pressure...
Id check it asap, because if it breaks it will wreck the engine.
You have to get under the car and remove the big nut on the side of the oil pump and its in there.
http://www.clever-trevor.net/part/477/oil-pressure...
Spring is an easy fix but if that fails to fix it the next possible problem is the woodruff key on the end of the pump assembly. Unfortunately not such an easy fix. One clue is that when it goes you also lose power assisted steering for the few seconds while the cog is slipping as the PAS pump is on the same shaft. If you lose oil pressure and the PAS is still working the spring is much more likely.
fatjon said:
Spring is an easy fix but if that fails to fix it the next possible problem is the woodruff key on the end of the pump assembly. Unfortunately not such an easy fix. One clue is that when it goes you also lose power assisted steering for the few seconds while the cog is slipping as the PAS pump is on the same shaft. If you lose oil pressure and the PAS is still working the spring is much more likely.
Sorry a bit of a dumb newbie, last time i had an AJP was in 2002 for 6 months.. had RV8 & SP6 since..when I first noticed, is that on start it didnt have more than 10psi pressure for 2 secs, then jumped to 40psi..
When engine was warm, no problems as I said 60+psi, and 30+ at idle.
what are typical pressures?
The oil level is full as much as I can make out, thats why I thought gauge problem..
Edited by C15 on Thursday 7th October 11:09
Gassing Station | Cerbera | Top of Page | What's New | My Stuff


