Rocker covers
Rocker covers
Author
Discussion

SILICONE KID

Original Poster:

14,997 posts

262 months

Thursday 7th October 2010
quotequote all
Im removing the rocker covers and having them powder coated.What size and type socket do i need to remove the bolts.Im replacing them with Allen key type and useing rubber gaskets..

slideways

4,101 posts

252 months

Thursday 7th October 2010
quotequote all
1/4" drive 8mm long reach double hex

Chimpaholic

9,637 posts

210 months

Thursday 7th October 2010
quotequote all
Daz, use the rubber gaskets when you put the covers back on.

Much better than the old cork type.

Use a little super glue to hold the rubber gasket to the cover, this makes fitting much easier.

You are right to use the allen cap head bolts, makes removal next time easier too.

Best regards, Dave.

Derek Smith

50,032 posts

279 months

Thursday 7th October 2010
quotequote all
Points, so to speak, are covered here: http://www.rv8r.co.uk/rocker.html

I discussed the double helix bolts at a specialist nut and bolt store, Namrick, and they suggested that the originals be retained as the torque is distributed over twelve points rather than just the six in the case of alan or standard, six-sided bolts. Can be handy as the bolts can be 'reulctant' to come undone as you don't often remove the rocker covers.

That's generated some comments on here before. I'm no specialist so am just repeating what I've been told by one.

haircutmike

22,511 posts

235 months

Friday 8th October 2010
quotequote all
I would like to replace my bolts as I have a mix fitted.

Where can I obtain the correct bolts?

If not, what length, thread etc.

Cheers.

Chimpaholic

9,637 posts

210 months

Friday 8th October 2010
quotequote all

Derek Smith

50,032 posts

279 months

Friday 8th October 2010
quotequote all
The parts numbers for the rocker cover bolts are: ERR7370 and ERR7371. Two numbers required as there are two different lengths. It is not generally a ‘stock item’ so will have to be ordered.

haircutmike

22,511 posts

235 months

Friday 8th October 2010
quotequote all
Thanks guys, ordered, job done, (well nearly).

Derek, will forward pics of diff removal shortly.

spend

12,581 posts

282 months

Friday 8th October 2010
quotequote all
Studs make dropping on the gasket, cover & washers on a piece of pee wink You just need to be a bit clever finding funky nuts that are easy to use.

SILICONE KID

Original Poster:

14,997 posts

262 months

Friday 8th October 2010
quotequote all
The colour im going for is satin black ,45pounds from the wheel works in Nottingham.They powder coated some MGB wheels some years ago and did a good job.It`s a very easy job because my Power steering vessel as be re located and i don`t have anything in the way.The main reason im having them powder coated is they look a mess after lay up over winter.I get a white type powder building up because my garage can get a little damp even with the dehumidifier is on.Bolts and rubber gaskets purchased from fleabay..