whistling noise from plenum - video
whistling noise from plenum - video
Author
Discussion

darkcat

Original Poster:

2,354 posts

201 months

Friday 8th October 2010
quotequote all
I have a painful whistling noise intermitently coming from the back of the plenum area, it seems to be vacuum related (i.e wont happen with the throttle open)

i can guarantee that its not a bearing or mechanical! its air.....

see:
http://www.youtube.com/watch?v=lkZtlPnUGQg


selnic

467 posts

298 months

Friday 8th October 2010
quotequote all
Have seen / heard it before on my brothers Chimaera, turned out to be the gasket on the casting which holds the stepper motor to the plenum.


Edited by selnic on Friday 8th October 18:07

Barkychoc

7,848 posts

235 months

Friday 8th October 2010
quotequote all
Theres a small rubber pipe that goes from the fuel pressure regulator (at the end of the fuel rail) to a small union tucked right underneath the housing where the stepper screws in - check it hasn't fallen off.

TVR Beaver

2,874 posts

211 months

Friday 8th October 2010
quotequote all
Whats that tap... does it stop when you close it?...
I'd say air screw... .mine did it once... a most strange noise indeed... give it 1/2 a turn see if it goes away...

Edited by TVR Beaver on Friday 8th October 21:06

darkcat

Original Poster:

2,354 posts

201 months

Saturday 9th October 2010
quotequote all
selnic - Will check that, i had it off some time ago so could be. have a spare somewhere.

barkychoc - checked that yeah, i would imagine id have fueling problems too if that was off...

tvr beaver - its a restrictor i fitted when i was having high idle issues. if i close it the engine stops! tried a spare normal tube but didnt help.

Im starting to think its coming from the stepper casting, so will look at that later

More Steam

698 posts

221 months

Saturday 9th October 2010
quotequote all
Have you tried listening through a hose? Apparently that's a good way of narrowing where noises are coming from.

haircutmike

22,511 posts

235 months

Saturday 9th October 2010
quotequote all
More Steam said:
Have you tried listening through a hose? Apparently that's a good way of narrowing where noises are coming from.
+ 1,

Use a 2 foot length of small bore hose, block the other ear, you will be amazed how good it is, better then my wifes stethascope!

Yes, she is a nurse, and it's not from her dressing up outfit wink.

TVR Beaver

2,874 posts

211 months

Saturday 9th October 2010
quotequote all
Did you try the air screw?..

haircutmike

22,511 posts

235 months

Saturday 9th October 2010
quotequote all
TVR Beaver said:
Did you try the air screw?..
I Have a noise similar but not as loud that comes and goes.

If I adjust the bleed screw I can get rid f it at the cost of a lower unacceptable idle speed.

I believe the throttle pot needs adjusting properly, (or is that rubbish?).

GarethC

8 posts

196 months

Sunday 10th October 2010
quotequote all
I had exactly the same problem. Try re-aligning the small L shaped pipe from the plenum to the rocker breather.

That cured mine

darkcat

Original Poster:

2,354 posts

201 months

Monday 18th October 2010
quotequote all
nothing seems to be helping, not yet tracked down a bit of pipe..

what is the "air screw"??

is it possible that it could come from the fuel pressure regulator??

TVR Beaver

2,874 posts

211 months

Monday 18th October 2010
quotequote all
The air screw or air bypass screw.. or idel screw is the one on top of the plenum next to the butterfly (RHS)....
I'm sure this will be your issue but you obviously don't believe me laugh

BliarOut

72,863 posts

270 months

Monday 18th October 2010
quotequote all
Pull pipes off and then replace until it stops biggrin