a8 front removal d3
Discussion
I looked it up today. You get 2.5 hours to do the fans. Including time to take the bumper cover and bumper beam off and move the lock carrier forward and drain and fill the coolant.
IIRC yours is a V8? it definatly cant be done with the front on.
You need to drain the coolant, take the rad hoses off and parcially remove the rad.
To get the bumper cover off, you need the under tray off, the inner wheel arch liners off or at least pulled back, there are 3 10mm bolts each side of the bumper to the inner wings you need acess to those. Them some torx fixings across the top of the grille area.
Then the beam and lock carrier should be visable and easy.
Take care removing the bumper cover if you have H/Lamp power wash, you dont want to break the pipework.
I cant copy the instruction from ELSA (1) for legal reasons, and (2) because its not possible.
But I did find this pic online which should help with the bumper cover.

IIRC yours is a V8? it definatly cant be done with the front on.
You need to drain the coolant, take the rad hoses off and parcially remove the rad.
To get the bumper cover off, you need the under tray off, the inner wheel arch liners off or at least pulled back, there are 3 10mm bolts each side of the bumper to the inner wings you need acess to those. Them some torx fixings across the top of the grille area.
Then the beam and lock carrier should be visable and easy.
Take care removing the bumper cover if you have H/Lamp power wash, you dont want to break the pipework.
I cant copy the instruction from ELSA (1) for legal reasons, and (2) because its not possible.
But I did find this pic online which should help with the bumper cover.

Removing and installing radiator cowl
Removing
– Drain off coolant
– Unplug electrical connector leading to radiator fan (right-side).
– Move wires clear at rear of lock carrier.
– Detach coolant pipe (bottom) from radiator cowl
– Move breather pipe at top of radiator cowl clear.
– Compress retainer catches and detach air duct from lock carrier (front right).
– Release both retaining pins for radiator cowl and pull out upwards
– Tilt top edge of radiator cowl forwards.
– Reach behind radiator cowl and unplug electrical connector -arrow- for radiator fans.
– Remove radiator cowl.
Installing
Installation is carried out in the reverse order; note the following:
– Fill system with coolant
Removing
– Drain off coolant
– Unplug electrical connector leading to radiator fan (right-side).
– Move wires clear at rear of lock carrier.
– Detach coolant pipe (bottom) from radiator cowl
– Move breather pipe at top of radiator cowl clear.
– Compress retainer catches and detach air duct from lock carrier (front right).
– Release both retaining pins for radiator cowl and pull out upwards
– Tilt top edge of radiator cowl forwards.
– Reach behind radiator cowl and unplug electrical connector -arrow- for radiator fans.
– Remove radiator cowl.
Installing
Installation is carried out in the reverse order; note the following:
– Fill system with coolant
Gassing Station | Audi, Seat, Skoda & VW | Top of Page | What's New | My Stuff


