Does this sound like the gauge or some more serious ?
Discussion
Hi,
Took my Chim out for a run yesterday and noticed that until the engine temp reached about 60 degrees, the oil pressure gauge rose and fell with acceleration, all the way upto 90 psi !
No warning lights came on, and as said, once the engine reached 60+, the gauge read 30-40 psi as it normally does.
Can anyone give any thoughts please ?
Thanks in advance.
Took my Chim out for a run yesterday and noticed that until the engine temp reached about 60 degrees, the oil pressure gauge rose and fell with acceleration, all the way upto 90 psi !
No warning lights came on, and as said, once the engine reached 60+, the gauge read 30-40 psi as it normally does.
Can anyone give any thoughts please ?
Thanks in advance.
Gauge, or dodgy wiring/sender.
I remember cacking myself once when pressing on in the outside lane I did my check of the dials and the oil pressure read zero despite no warning lights coming on. I pretty quickly backed off the throttle and as I did the pressure rose again, back on and it dropped. So I took a more sedate speed and kept an eye on it and it was all over the place. Funny thing is it never did it again, odd cars!
The gauge is only a guide, if there was something more fundamentally wrong there would be other signs too, like a loud rattling and bits of engine on the floor.
I remember cacking myself once when pressing on in the outside lane I did my check of the dials and the oil pressure read zero despite no warning lights coming on. I pretty quickly backed off the throttle and as I did the pressure rose again, back on and it dropped. So I took a more sedate speed and kept an eye on it and it was all over the place. Funny thing is it never did it again, odd cars!
The gauge is only a guide, if there was something more fundamentally wrong there would be other signs too, like a loud rattling and bits of engine on the floor.
Thanks for the reply .Mark. Was thinking sender as the car seems to be running fine and no engine bits on the floor etc.
What is weird is that for 2.5 years the car was on my drive under a waterproof cover and never had any strangies. Now it is garaged ?? Go figure !!
I get and check it out later in the week.
What is weird is that for 2.5 years the car was on my drive under a waterproof cover and never had any strangies. Now it is garaged ?? Go figure !!
I get and check it out later in the week.
funnily enough, same here. When mine lived outside (for about 4 years) it worked perfectly, for the last 5 years it's been garaged and I have had more issues. I think it's because I used it more when it was outside, now it's garaged it's easier to take the car in the drive.
Terrible I know!
Terrible I know!
This is typical of the oil pressure relief sticking when the engine is cold. Its certainly an issue on the pre-serp engine where the cylindrical valve jams in the aluminium oil pump housing due to scoring and wear. There was even a modification sold where you replaced the valve with a ball shaped one so it would not stick. I would not leave it like this as it puts undue stain on things when cold, and can also mean the valve sticks open so the pressure can drop to low when it should be shutting. I dont know if the serp engine has the same issues.
Mine suddenly started reading 90psi even without the engine running (but with the ignition on obviously) and only went down by about 10psi on tickover.
My service guy put it on the ramps and by fiddling with the wiring he was able to say it was the sender, not the gauge so a week later job done.
About £70ish for the sender from TVR Car Parts + about 10 minutes workshop time.
Make sure you get the right one as there are at least two, so check yours against their webpage.
I poked a camera under the car to get a photo.
My service guy put it on the ramps and by fiddling with the wiring he was able to say it was the sender, not the gauge so a week later job done.
About £70ish for the sender from TVR Car Parts + about 10 minutes workshop time.
Make sure you get the right one as there are at least two, so check yours against their webpage.
I poked a camera under the car to get a photo.
If you had no oil pressure then the red warning light would come on.
Its more than likely as Spend says the connector , its next to the oil filter.
You can check the guage and wiring by disconnecting the connector on the sender and connecting to earth and then check the gauge reading. Sender is very easy to change with no loss of oil.
Its more than likely as Spend says the connector , its next to the oil filter.
You can check the guage and wiring by disconnecting the connector on the sender and connecting to earth and then check the gauge reading. Sender is very easy to change with no loss of oil.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff


