Chimera seats, can they be adapted to go further forwards ?
Chimera seats, can they be adapted to go further forwards ?
Author
Discussion

Ultimatequinoxe

Original Poster:

18 posts

199 months

Saturday 16th October 2010
quotequote all
Just drove a customers 1997 Chimera to its new owner, but the new owner is a lady of little height and the seat stops to far back for her to reach the pedals. Has anyone stuck different rails on the base or seat, or in some other way got the seat further forwards for shorter drivers ?

Thanks !

spend

12,581 posts

282 months

Saturday 16th October 2010
quotequote all
If its just the legs, screw the pedals out (they are adjustable). Leven used to do some extra long pedal replacements - someone might still have some they don't need?

You could move the runners forward, but the tub will need careful re-inforcement, and I'm not sure if there is enough room for the seat as the trans tunnel narrows the space available a bit?

Ultimatequinoxe

Original Poster:

18 posts

199 months

Saturday 16th October 2010
quotequote all
Ah, that helps a lot thank you ! We did jokingly say to the lady about extending the pedal's and I ( not being a TVR owner myself yet ) did not realize the pedals were adjustable or expendable. This info will help the new owners I am sure.

rickprice

498 posts

269 months

Monday 18th October 2010
quotequote all
The drivers seat is mounted on the floor (rear) and a small section of boxing (front) - at least it is in my 2000 model.

You could easily get someone who's handy with metal to fabricate a full-length section of boxing, whereupon you can mount the seat wherever you like. As long as the centre of gravity sits between the hole in the floor, should not be an issue.

Beware of getting in and out, though... I speak from personal experience because I did this to get a better view (I'm 5'5" on a warm day) and found my legs kept getting caught on the steering wheel.

I also took the opportunity to reinforce the mounts with metal beneath the car. When I lifted the seats out I was shocked at what was bearing my weight!!!

I have now returned to the original design because the extra height I added was too much.

In the end I swapped the driver and passenger seats around and discovered how much more my old drivers seat was sagging, and therefore how higher I sat in the (nearly unused) passenger seat.

Hope this is helpful,

Rich



anonymous-user

85 months

Monday 18th October 2010
quotequote all

I have just taken the seats out my 1999 car, and found the passenger side seat on the floor , but the drivers side on two small box sections at the front only.
I am 6'3'' so I am going to refit as the passenger side directly to the floor for the drivers side also.
See if this gives me a bit more room.

Are the box sections at the front factory fitted for short drivers. My pedals are wound right up to the driver also.

SILICONE KID

14,997 posts

262 months

Monday 18th October 2010
quotequote all
You will have to re drill the floor if you remove the small box section spacer and it makes the seat fit flat.