Discussion
I have willingly overfilled the gearbox. Not by a lot, but what was I going to do with the oil leftover?
Shortly after, I started noticing a gearbox oil leak coming from the back of the box. There would be a small puddle under the car every day.
I have then drained the box and refilled it with exactly the right amount as stated in the bible.
But I still do get the puddle on the garage floor.
Did I destroy the sealing at the end of the box?
How can I fix it now? Does that mean taking the gearbox down? Is there somewhere a step by step guide to dismantle the box from the car?
Thanks for your help.
Regards
Philippe
Shortly after, I started noticing a gearbox oil leak coming from the back of the box. There would be a small puddle under the car every day.
I have then drained the box and refilled it with exactly the right amount as stated in the bible.
But I still do get the puddle on the garage floor.
Did I destroy the sealing at the end of the box?
How can I fix it now? Does that mean taking the gearbox down? Is there somewhere a step by step guide to dismantle the box from the car?
Thanks for your help.
Regards
Philippe
Ok, then I have not overfilled the box. I have just put more oil than stated in the bible.
But since then, I have this leaks clearly coming from the back of the box (red oil covering the exhaust silencer and the metal plate underneath it).
That must certainly be the gasket which is shot.
Therefore, I need to change it.
Could someone explain (or point me to the right direction) how to access this sealing (removal of the box?)?
Thanks and regards
Philippe
But since then, I have this leaks clearly coming from the back of the box (red oil covering the exhaust silencer and the metal plate underneath it).
That must certainly be the gasket which is shot.
Therefore, I need to change it.
Could someone explain (or point me to the right direction) how to access this sealing (removal of the box?)?
Thanks and regards
Philippe
Bonjour phillipe, it sounds as though the oil seal on the back of the gearbox, where the propshaft enters is the scource of your oil leak. You will need the car on axle stands or similar, you will have to drop the exhaus first so you can see for certain that it is this seal thats leaking. and if so then remove the propshaft, you may well be able to remove the oil seal with the gearbox in situ. I have not done this on my chimaera, but i did do it, gearbox in situ, on my S3. Maybe someone on here has done this on there chim, and could advise you. If you have somehow managed to overfill the gearbox, and thus created more internal pressure,this oil seal is an obvious point of release. I would run the car for a while, the leak may eventually stop, or better still, drain and reinstate the correct amount of oil and see if the leak still persists. If so then change the oil seal. good luck Tom.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff



