Replacement dash keeping original
Discussion
The different tree thing is completely insignificant. The odds of the original panels coming from the same strip of veneer are tiny so there's no need to replace both at the same time. I think your best bet is the Wanted adverts on here, and TVRCC if you are a member.
I don't know of anyone making new ones with veneer, most people are after alloy / carbon fibre ones. So your best bet is getting a good used one from someone upgrading - I sent my veneer radio panel to someone on PH when I fitted the Leven alloy dash. Alternatively you could get it re-veneered by a pro.
Finally, might be worth contacting Surface & Design (ex-TVR staff) http://www.surfaceanddesign.com/ - they might be able to help.
I don't know of anyone making new ones with veneer, most people are after alloy / carbon fibre ones. So your best bet is getting a good used one from someone upgrading - I sent my veneer radio panel to someone on PH when I fitted the Leven alloy dash. Alternatively you could get it re-veneered by a pro.
Finally, might be worth contacting Surface & Design (ex-TVR staff) http://www.surfaceanddesign.com/ - they might be able to help.
You could try searching this web site (Advanced: "Veneer" in TVR folder/Chimaera??)
Or try these people for the best results: http://www.london-carriage-craft.com/tvr.htm
Trev
Or try these people for the best results: http://www.london-carriage-craft.com/tvr.htm
Trev
I've been doing new replacement dashes for the Chim and Griff for over four years, but am stopping when I've used up parts left in stock (was doing one a week, now down to about one a month, so now it's not really worth it).
http://www.pistonheads.com/sales/288411.htm
For best results you really need to get the two parts done at the same time so that they match.
In this particular case, if there is plenty of old wood left on your radio panel, the new veneer can be coloured, to match, so that it hopefully then matches your main dash. But for best I would do both dashes.
I understand that TVR used the one cnc firm to make the metal backing plates and four different veneering firms over the life of the Chim/Griff model.
http://www.pistonheads.com/sales/288411.htm
For best results you really need to get the two parts done at the same time so that they match.
In this particular case, if there is plenty of old wood left on your radio panel, the new veneer can be coloured, to match, so that it hopefully then matches your main dash. But for best I would do both dashes.
I understand that TVR used the one cnc firm to make the metal backing plates and four different veneering firms over the life of the Chim/Griff model.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff



