Fuel pipe replacement advice
Fuel pipe replacement advice
Author
Discussion

anonymous-user

Original Poster:

85 months

Monday 18th October 2010
quotequote all
Had a bad petrol smell coming from the back of the car, had the smell for a good few months though it went through its last service in May with no problems, however after filling it up and getting it ready for the Sunday Service I decided to remove the rear wheel and noticed the below. yikes

The fuel line has a small hole in it near the filter on the line between the fuel filter and the engine.

The pic below was taken about 5 mins after I turned off the engine and the pressure still in the system was making a nice fountain spraying on to part of the chassis.





As my local independant has now stopped TVR Servicing and gone, can you recommend what pipe I should get. I read Viton lined is the best to use. I want to get the right stuff so I can run it down to a local garage to fit.
Can anyone recommend the best place to get this from?

Thanks in advance

TJC46

2,199 posts

237 months

Monday 18th October 2010
quotequote all
Any good motor factors should sell the correct dia petrol hose. Make sure you use only petrol hose. I hope you dont intend to drive your car to the garage yikes You have done very well to spot that tiny leak, but better to be safe than sorry. Dont drive the car anywhere!

anonymous-user

Original Poster:

85 months

Tuesday 19th October 2010
quotequote all
Just got to get the pipe now and get it to the garage, it's only about a mile away, so I think I will wrap it up and take it down there.

I think it has been leaking for a while, luckily I noticed it before anything happened.

Geo28

262 posts

248 months

Tuesday 19th October 2010
quotequote all
Make sure it is rated for high pressure fuel injected systems and suitable for unleaded fuels. Think diameter is 7mm but not entirely sure.

pbaker43

268 posts

199 months

Tuesday 19th October 2010
quotequote all
just done all my pipes on the rear right from the tank to the copper pipe under the driver seat.1. The fuel pipe from the tank to the pump is 10mm I/D 12mm O/D the rest of the system after the pump is 7mm (Demon Tweeks).

anonymous-user

Original Poster:

85 months

Thursday 21st October 2010
quotequote all
I imagine these are are standard rather than pre-formed pipes. Just got to get some now and get them fitted at my local garage.