Centre Instrument Panel

[Dave222]

Bulb has gone in the boost gauge and the fitment of the panel is a bit loose. Can anyone tell me how to get the thing off as I can get it so far but it appears to be held by the heater control cables.
Cheers guys. Dave

[Adrian W]

can you see this

http://www.nobleparts.co.uk/forum/viewtopic.php?t=...

[Dave222]

Adrian, no I can't, I,ve tried to register on that website but never get the e-mail back.
Dave

[ThatPhilBrettGuy]

Dave222 said:

Adrian, no I can't, I,ve tried to register on that website but never get the e-mail back.
Dave

I'll sort that for you later with a few others. Remember, if I can't work out if you actually own a Noble when you register nothing happens....

[Dave222]

OK mate I will try again now, by the way my car is gunmetal grey, reg no. M12 CTO.

[Dave222]

I have tried to register again but its telling me my e-mail address is already being used ([e-mail])if you can sort me out it would be much appreciated. Dave

[The devil]

It's a bugger
I have now had made and installed a new custom designed panel as they are such a pig to get off
Good luck

[ThatPhilBrettGuy]

Dave222 said:

I have tried to register again but its telling me my e-mail address is already being used ([e-mail])if you can sort me out it would be much appreciated. Dave

I said later, not now.

[F.C.]

Dave222 said:

Bulb has gone in the boost gauge and the fitment of the panel is a bit loose. Can anyone tell me how to get the thing off as I can get it so far but it appears to be held by the heater control cables.
Cheers guys. Dave

Probably teaching you to suck eggs here but while it's off replace all the bulbs with quality lamps (not Halfrauds specials) or you'll have to go through the PAIN all over again.

[andygtt]

The devil said:

It's a bugger
I have now had made and installed a new custom designed panel as they are such a pig to get off
Good luck

any pics? also of the location of the holes you mentioned you drilled so you could get it off

[The devil]

pictures later

[The devil]

Evening

There you go. The bottom one is accessible from the drivers side unless you have chubby arms, it needs an 8mm socket on the end of it.
I found the upper studs by pushing a piece of paper in from the side but hopefully you may be able to guage it from my photos.

[The devil]

Photo of the back