Stepper Motor Disconect.
Discussion
Hi Guys - Most of the time my Chimaera tickover behaves itself, thanks to keeping the stepper motor clean, but do carry the cleaning kit and spanner for the odd time when out and about when the tickover becomes unstable.
The last time when out, she started playing up, so pulled over whipped out the offending item for a clean up and refitted, got a lot of comments and grins from the passing public which started to get to me.
So not wanting the abuse again, let the car warm up and got a steady and stable idle and then disconnected it. Have to say, apart from a little tricky to start from cold, eveything seems to be running better, and all the problems seem to be solved.
Is this going to cause any problems later, say if I want to connect it back again.
Many thanks
Andy
The last time when out, she started playing up, so pulled over whipped out the offending item for a clean up and refitted, got a lot of comments and grins from the passing public which started to get to me.
So not wanting the abuse again, let the car warm up and got a steady and stable idle and then disconnected it. Have to say, apart from a little tricky to start from cold, eveything seems to be running better, and all the problems seem to be solved.
Is this going to cause any problems later, say if I want to connect it back again.
Many thanks
Andy
You can achieve much the same result by installing a restictor in the air hose that links the stepper to the other side of the throttle plate.... something like a 5.5 or 6mm drilling in an othewise blank plug (from memory) restricts the air allowed through by the stepper to just enough to lift above a good idle (ie not enough to be annoying). You might need to play with the drilling size but you get the idea and this avoids having to leave the thing disconnected..
Alternatively go MS or Emerald or whatever
Alternatively go MS or Emerald or whatever

You can run with the stepper as you say, and rely just on the base idle without an major issues. If you just clean the stepper motor cone, it does not get rid of the carbon that gets in the keyway, so they can still play up. There are also condtions when the tickover is held high on purpose by the ECU to prevent catalyst damage in certain fault conditions, and fitting a restrictor is not addressing the root cause of the problem, just masking it. A fault code reader should tell you if such a situation has occurred. In terms of general wear and tear on the stepper, the bearing in the back are steel and can rust overtime, so the control becomes erratic even after a good clean.
Quinny said:
I don't understand why you would need to keep cleaning the stepper on such a regular basis??
I guess I've cleaned mine 2 or 3 times in 10 years....
Interesting.I guess I've cleaned mine 2 or 3 times in 10 years....
I gave my stepper a good clean a couple of months ago. But, now the
cold weather's here, every now and then after a mile or so of
driving my tickover drops very low. I was gonna 'whip it out'(oooer)
but could it be something else?
John
The stepper only does what the ECU tells it to and that's based on all sorts or other parameters including the input from the various sensors around the motor and on the diff. Any 'proper' diagnosis will need to ensure the sensors themselves (and their respective leads and plugs etc) are within spec and, even then, experience indicates glitch free idle control may not result. Far too much emphasis on 'cleaning the stepper' for these issues I would suggest 

Gassing Station | Chimaera | Top of Page | What's New | My Stuff


