remove the butterfly
Discussion
Hello.I have removed all the bits off the plenum.Hope they go back in order
How do i remove the butterfly and the shaft thing as they have rubber seals.I don`t want to melt them in the oven after powder coating.Do you think the plenum will be ok being powder coated or shell i get it painted.
don`t want it to warp


How do i remove the butterfly and the shaft thing as they have rubber seals.I don`t want to melt them in the oven after powder coating.Do you think the plenum will be ok being powder coated or shell i get it painted.
don`t want it to warp

SILICONE KID said:
please explain.
.thought it would be a simple job.Its all in bits now.
Right, just for you our 'lil fiddler......
.thought it would be a simple job.Its all in bits now.The software in your ECU will be set up for a min/max value feedback from your TPS (the"load" part of your maps), now you have taken it all apart the chances of it going back in exactly the same way is minimal. Therefore, when the plenum is re-assembled and re-fitted to the engine the min/max values will need to be re-learnt into the ECU..
Do you know how to do this??????????
ETA, Daz , no matter how much s
t you generate/take you always come back, in a frustrating way, hats off to ya....If you are lucky you may have witness compression marks which enable you to refit the TPS in pretty much the same place. Yet any re-alignment of the butterfly and slight misalignment of the TPS might affect the fine tuning of your map even though you reset the static points in the ECU... ie minor map tweaks may be required which could lead to major calamities depending on which 'operator' executes them 
Theres a bit more to stripping parts, sealing important bits, masking up then re-assembling in coating components than a simple take'n'bake garlic stick

Theres a bit more to stripping parts, sealing important bits, masking up then re-assembling in coating components than a simple take'n'bake garlic stick

SILICONE KID said:
Wish some one had mentioned it,I asked about powder coating the plenum the other
day
daz what you need to do is buy a pair of the biggest boxing gloves you can get, and when you want to work on your car, get the misses to glue them to your hands.....day

Edited by SILICONE KID on Wednesday 20th October 21:44
hey we all love you really, what you are going to need to do now is make sure you have your megasquirt map saved (safely somewhere), when you put your plenum back together you WILL need to make sure that that the tps reading is exactly the same as what it was before you stripped it, its not difficult but just dont go adjusting things willy nilly or you will need a remap! HOMER
Ant. said:
now you have taken it all apart the chances of it going back in exactly the same way is minimal.
on my 1998 chim there is no adjustment on the throttle pot mounting so it will always go back in the same position.Is this not true of all chims or are the earlier ones adjustable?
Gassing Station | Chimaera | Top of Page | What's New | My Stuff






