Winky (headlights! complete with video)
Discussion
Switch them on and this happens continuously:
Any suggestions on where to start
http://www.youtube.com/watch?v=iq2yXjxYo6U
Any suggestions on where to start
http://www.youtube.com/watch?v=iq2yXjxYo6U
What relay layout do you have? Is it like Jeff Morgan's on the other current lights thread (with the fuses below the relays) or do you have fuses behind the glovebox and relays below it, or some other incarnation?
As it's a 'D' plate car I'd guess at the latter, in which case it'd probably be like the 390SE layout. So you'll have more relays than you can shake a cuniform stick at
The lights seem to be staying lit which would tend to rule out the main lights switch and column dip/main switch. The pod motor fuses must be OK or the motors wouldn't lift. Ditto the motor earths. The control signal to both motors is paralleled; they're both working after a fashion so that must be OK. Odds-on it's a duff diode down by yer relays. Outside chance it's faulty switches in the pod motors themselves, but for both to fail at once...!!!
As it's a 'D' plate car I'd guess at the latter, in which case it'd probably be like the 390SE layout. So you'll have more relays than you can shake a cuniform stick at

The lights seem to be staying lit which would tend to rule out the main lights switch and column dip/main switch. The pod motor fuses must be OK or the motors wouldn't lift. Ditto the motor earths. The control signal to both motors is paralleled; they're both working after a fashion so that must be OK. Odds-on it's a duff diode down by yer relays. Outside chance it's faulty switches in the pod motors themselves, but for both to fail at once...!!!
Gassing Station | Wedges | Top of Page | What's New | My Stuff




That's much more impressive than my pod problem Dave. 

sorry mate..
k!!
Maybe needs to be something a bit more staccato.. how about Agadoo?
glad someone else has the problem !! Had this a while back on a Lotus Esprit. It was a ground fault, one of the grounds had come out of the push in connector.Re-connected it and they worked normally.