leaking rocker cover gasket a4 18 turbo;
leaking rocker cover gasket a4 18 turbo;
Author
Discussion

chezzer

Original Poster:

66 posts

238 months

Monday 25th October 2010
quotequote all
hello anybody else experienced a leaking gasket? ive had a new one replaced and it still leaks in the exactly the same place causing oil to leak over the exhaust grrr!

Tame Technician

2,467 posts

235 months

Monday 25th October 2010
quotequote all
Is it not the timing chain tensioner housing gasket leaking. Looks like its the cam cover but it isnt, very comon misdiagnosis. Right at the back of the head.

chezzer

Original Poster:

66 posts

238 months

Tuesday 26th October 2010
quotequote all
ahh could be its leaking in that area replaced the rocker gasket and it still leaks in the exact same place mmmm right onto the gearbox and exhaust and when it gets hot it bloody stinks lol are these gaskets easy to replace then? thanks for your help paul

944fan

4,962 posts

216 months

Tuesday 26th October 2010
quotequote all
If you do it the correct way (i.e. the way Audi tell you it should be done) then it is a nightmare of a job, the front bumper comes of, lock carier comes forward, the timing belt comes off, the cams come out. Loads of work, and loads of specialist tools needed.

There are some people on the Internet who have not bothered with all that and have just lifted the cams slightly and slid the gasket out with some picks and pliers. The problem with this is it is near impossible to properly clean the matting surfaces and you are likey to spring a leak from there shortly after. I am sure TT will agree this is not the recommended way to go about it.

My 2.4 has been leaking from there for a while, I left until the timing belt needed doing again as that has to come off to do that.

chezzer

Original Poster:

66 posts

238 months

Tuesday 26th October 2010
quotequote all
hi thanks for your last reply but the leak is coming from near the timing chain not the timing belt i have check for leaks near the timing belt area and there is none just at the bk of the head very near the timing chain area it normally takes a few days for it to start dripping on to the gearbox and exhaust area but its getting annoying now lol.

944fan

4,962 posts

216 months

Tuesday 26th October 2010
quotequote all
Yeah I understood where you meant it was coming from . What I was saying is to get the cam adjuster mechanism out (which acts on the cam chain) you have to remove the timing belt to enable you to get the cams out so you can remove the adjuster and fix the leak.

Because of the labour involved in doing that is why I left it until the timing belt was coming of anyway.

Think something got lot in translation! beer

Tame Technician

2,467 posts

235 months

Tuesday 26th October 2010
quotequote all
I take the cams right out, is the only way to do it propperly.

However it can be done without disterbing the belt if you cable tie the belt to the from pulley and tilt the cams, but I dont like this way as pointed out, you are trying to make an oil tight seel, so serface need to be completely clean and a very light smearing of sealant applied.

chezzer

Original Poster:

66 posts

238 months

Tuesday 26th October 2010
quotequote all
ahh shame u wasnt local tt i would of had some work for yousmile