Replacing wing mirror
Discussion
Basically some w
r has broken my wing mirror!!! I have a replacement one and need to fit asap. Even with the mirror hanging off I still can't get to the grub screw and the cover seems to be stuck ! Also can I replace the internals and keep the outer shell for colour purposes? thanks Scott
r has broken my wing mirror!!! I have a replacement one and need to fit asap. Even with the mirror hanging off I still can't get to the grub screw and the cover seems to be stuck ! Also can I replace the internals and keep the outer shell for colour purposes? thanks ScottI replaced the wing mirror 'turret' on mine last week, as the turret was knackered I butchered it off, the grub screw sat so low in the recess that it would have been impossible to do in situ but I believe the way to fit a entire mirror is to unscrew the entire mirror from the door, when i replaced the turret I made 2 changes, the grub screw was replaced by a cut down M6 bolt which can be slowly and patiently tightened in the recess and finished off with loctite, also the top mirror fixing which is secured from inside the turret up and into the cast boss was. Replaced by an M6 bolt and nylon nut after drilling the boss through, this meant (with a slight notch in the plastic shroud) i can tighten this without any problem when assembling and if it comes loose or if I want to remove it at a later date.
Gassing Station | Chimaera | Top of Page | What's New | My Stuff





