Chassis Transmission Bolts
Chassis Transmission Bolts
Author
Discussion

BennyHill

Original Poster:

18 posts

202 months

Sunday 7th November 2010
quotequote all
I am in the final stages of preparation for a body lift. All chassis bolts have been removed except for the 2 in the transmission tunnel area. I have removed the Centre Armrest and can see the two bolts and the small acces hole in the fibre glass, but how do I get a spanner onto them?? Do I have to cut the carpet around the access hole or is it possible to peel the carpet back?

Any advice much appreciated.

penno

241 posts

261 months

Sunday 7th November 2010
quotequote all
hi, when i did my body lift the bolts were further back than where you have marked i,e towards the bulkhead. I made a small slit downwards in the carpet and managed to get a 17mm ring spanner in to undo. You cannot see the splits in the carpets

spend

12,581 posts

282 months

Sunday 7th November 2010
quotequote all
With a lot of effort you can either remove the lower dash or lever it up & slide (haha) the carpet + insul out.

Probably much easier to cut a hole / v to get at the bolt head (having tried the above hehe )

hiltonig

3,153 posts

239 months

Monday 8th November 2010
quotequote all
Managed to get the carpet pulled down on the drivers side. The other one got at with a ratchet spanner no need to cut the carpet.

V8NRG

854 posts

274 months

Monday 8th November 2010
quotequote all
I managed to pull the carpet just enough to get acces with a spanner.

BennyHill

Original Poster:

18 posts

202 months

Monday 8th November 2010
quotequote all
Thanks for the feedback. I will try to pull the carpet down first, if that fails then I cut a small 3 sided window to access the bolts.

spend

12,581 posts

282 months

Monday 8th November 2010
quotequote all
Sounds like the cars with air vents don't have as much glue in that area as the early cars hehe I must have taken over 6 hours with knifes, spatulas, screw drivers, pry bars, most of the garage / garden / kitchen implements I could lay my hands on to free the damned stuff... and the early ones carpet is only laid just over the ridge - separate panel laid in the 'cubby'